相关论文: The Regenerative Current Mirror: A Very Low Power …

Switching uniformity, as a major challenge, hinders the practical implementation of \ac{RRAM} in memory application. Operating \ac{RRAM} in current mode, is proposed as an efficient method to improve programming schemes accuracy within the…

The Silicon Electron Multiplier (SiEM) is a novel sensor concept for minimum ionizing particle (MIP) detection which uses internal gain and fine pitch to achieve excellent temporal and spatial resolution. In contrast to sensors where the…

An analog integrated circuit has been designed, in a BiCMOS 0.8 micron technology, for the feasability study of the signal processing of the AMS RICH photomultiplier tubes. This low power, three channel gated integrator includes its own…

A transimpedance amplifier has been designed for scanning tunneling microscopy (STM). The amplifier features low noise (limited by the Johnson noise of the 1 G{\Omega} feedback resistor at low input current and low frequencies), sufficient…

This paper studies an architecture with digitally controllable gain and power consumption to mitigate the impact of process variations on CMOS low-noise amplifiers (LNAs). A \SI{130}{nm}, \SI{1.2}{V} LNA implementing the proposed…

This paper describes a CMOS analogy voltage supper buffer designed to have extremely low static current Consumption as well as high current drive capability. A new technique is used to reduce the leakage power of class-AB CMOS buffer…

We demonstrate that magnetic multilayer nanopillars can be efficiently protected from oxidation by coating with silicon. Both the protected and the oxidized nanopillars exhibit an increase of reversal current at cryogenic temperatures.…

This paper describes the design and testing results of an 8 channels preamplifier-discriminator circuit based on a resistive feedback Transimpedance Amplifier architecture and a Leading-Edge Discriminator stage for fast high-accuracy time…

Silicon photonics has emerged as the leading candidate for implementing ultralow power wavelength division multiplexed communication networks in high-performance computers, yet current components (lasers, modulators, filters, and detectors)…

Thin pad detectors made from 75 $\mu$m thick epitaxial silicon on low resistivity substrate were irradiated with reactor neutrons to fluences from 2.5$\times 10^{16}$ n/cm$^2$ to 1$\times 10^{17}$ n/cm$^2$. Edge-TCT measurements showed that…

The self-noise of capacitive sensors, primarily caused by thermal noise from the gate-bias resistor in the preamplifier, imposes a fundamental limit on measurement sensitivity. In electret condenser microphones (ECMs), this resistor…

CMOS-transistors circuits have been used as a conventional approach for designing an analog multiplier in modern era of industrial electronics. However, previous studies have shown, that based on the working region of transistors, such as…

This letter presents a novel adaptive power division strategy, which uses two rectifying diodes with nonlinear impedance characteristics that are configured in parallel to function optimally at their individual power levels. Through the…

In the context of the CERN EP R&D on monolithic sensors and the ALICE ITS3 upgrade, the Tower Partners Semiconductor Co (TPSCo) 65 nm process has been qualified for use in high energy physics, and adopted for the ALICE ITS3 upgrade. An…

In this paper, a low-noise CMOS image sensor with enhanced dynamic range (DR), using an in-pixel chopping technique, is presented. The proposed in-pixel chopping technique is used to reduce the low-frequency or 1/f noise of the source…

Activation functions are widely used in neural networks to decide the activation value of the neural unit based upon linear combinations of the weighted inputs. The effective implementation of activation function is highly important, as…

Silicon photo-multipliers (SiPM) have been replacing traditional photomultiplier tubes in most light sensing applications. However, when large detection surface coverage is needed, photomultipliers (PMTs) are still the preferred choice. The…

This paper presents an innovative in-pixel contrast enhancement circuit that performs image processing directly within the pixel circuit. The circuit can be tuned for different modes of operation. In foreground enhancement mode, it…

Low-noise microwave amplifiers are crucial for detecting weak signals in fields such as quantum technology and radio astronomy. However, designing an ideal amplifier is challenging, as it must cover a wide frequency range, add minimal…

Dynamic comparators are an essential part of low-power analog to digital converters (ADCs) and are referred to as one of the most important building blocks in mixed mode circuits. The power consumption and accuracy of dynamic comparators…