相关论文: Quasiparticle Generation-Recombination Noise in th…

We have directly measured quasiparticle number fluctuations in a thin film superconducting Al resonator in thermal equilibrium. The spectrum of these fluctuations provides a measure of both the density and the lifetime of the…

In this work, we designed and experimentally verified a highly integrated broadband entropy source for a quantum random number generator (QRNG) based on vacuum fluctuations. The core of the entropy source is a hybrid…

We measure temperature dependent quasiparticle fluctuations in a small Al volume, embedded in a NbTiN superconducting microwave resonator. The resonator design allows for read-out close to equilibrium. By placing the Al film on a membrane,…

Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90G Hz) using a superconductor-insulator-superconductor tunnel junction…

Quantum mechanics can strongly influence the noise properties of mesoscopic devices. To probe this effect we have measured the current fluctuations at high-frequency (5-90 GHz) using a superconductor-insulator-superconductor tunnel junction…

We report on the noise of a lumped element Direct Current Superconducting Quantum Interference Device amplifier. We show that the noise temperature in the 4 GHz-8 GHz range over ranges of 10's of MHz is below 1 kelvin (three photons of…

Using a quantum detector, a superconductor-insulator-superconductor junction, we probe separately the emission and absorption noise in the quantum regime of a superconducting resonant circuit at equilibrium. At low temperature the resonant…

We have measured the number of quasiparticles and their lifetime in aluminium superconducting microwave resonators. The number of excess quasiparticles below 160 mK decreases from 72 to 17 $\mu$m$^{-3}$ with a 6 dB decrease of the microwave…

We present measurements of the low-frequency noise of microstrip-coupled, lumped-element aluminum kinetic inductance detectors that use hydrogenated amorphous silicon parallel-plate capacitors (Al/a-Si:H MS-PPC-LEKIDs), which are under…

The separation and optimization of noise components is critical to microwave-kinetic inductance detector (MKID) development. We analyze the effect of several changes to the lumped-element inductor and interdigitated capacitor geometry on…

Superconducting high kinetic inductance elements constitute a valuable resource for quantum circuit design and millimeter-wave detection. Granular aluminum (GrAl) in the superconducting regime is a particularly interesting material since it…

An electrothermal model of Kinetic Inductance Detectors (KIDs) is described. The non-equilibrium state of the resonator's quasiparticle system is characterized by an effective temperature, which because of readout-power heating is higher…

A new type of radiation detector, a p-type modified electrode germanium diode, is presented. The prototype displays, for the first time, a combination of features (mass, energy threshold and background expectation) required for a…

One of the noise sources that currently limits gravitational wave (GW) detectors comes from the quantum nature of the light causing uncertain amplitude and phase. Phase uncertainty limits the precision of an interferometric measurement.…

We report photon-noise limited performance of horn-coupled, aluminum lumped-element kinetic inductance detectors at millimeter wavelengths. The detectors are illuminated by a millimeter-wave source that uses an active multiplier chain to…

Thin-film superconductors with thickness 30 to 500 nm are used as non-equilibrium quantum detectors for photons, phonons or more exotic particles. One of the most basic questions in determining their limiting sensitivity is the efficiency…

The presence of quasiparticles typically degrades the performance of superconducting microwave circuits. The readout signal can generate non-equilibrium quasiparticles, which lead to excess microwave loss and decoherence. To understand this…

We study the noise properties and efficiency of a mesoscopic resonant-level conductor which is used as a quantum detector, in the regime where transport through the level is only partially phase coherent. We contrast models in which…

The gravitational waveform of merging binary neutron stars encodes information about extreme states of matter. Probing these gravitational emissions requires the gravitational-wave detectors to have high sensitivity above 1 kHz. Fortunately…

Identifying, quantifying, and suppressing decoherence mechanisms in qubits are important steps towards the goal of engineering a quantum computer or simulator. Superconducting circuits offer flexibility in qubit design; however, their…