相关论文: Effect of initial microstructure on its evolution …
The first in situ quantitative synchrotron X-ray diffraction (XRD) study of plastic strain-induced phase transformation (PT) has been performed on $\alpha-\omega$ PT in ultra-pure, strongly plastically predeformed Zr as an example, under…
Under high pressure conditions, Zr undergoes a phase transformation from its ambient equilibrium hexagonal close packed $\alpha$ phase to hexagonal $\omega$ phase. Upon returning to ambient conditions, the material displays hysteretic…
Study of the plastic flow and strain-induced phase transformations (PTs) under high pressure with diamond anvils is important for material and geophysics. We introduce rough diamond anvils and apply them to Zr, which drastically change the…
Under high pressure, Zr undergoes a transformation from its ambient equilibrium hexagonal close packed $\alpha$ phase to a simple hexagonal $\omega$ phase. Subsequent unloading to ambient conditions does not see a full reversal to the…
Zirconium (Zr) is an important engineering material with numerous practical applications. It undergoes martensitic $\alpha$ to $\omega$ phase transformation (PT) at pressures that vary from 0.67 GPa to 17 GPa under different loading…
Rough diamond anvils (rough-DA) are introduced to intensify all occurring processes during an in-situ study of heterogeneous compression of strongly pre-deformed Zr in diamond anvil cell (DAC). Crystallite size and dislocation density of Zr…
With decreasing system sizes, the mechanical properties and dominant deformation mechanisms of metals change. For larger scales, bulk behavior is observed that is characterized by a preservation and significant increase of dislocation…
In this study, we use discrete dislocation dynamics (DDD) simulation to investigate the effect of heterogeneous dislocation density on the transition between quasi-elastic deformation and plastic flow in face-centered cubic single crystals.…
The effect of composition on microstructure both at the length scale of the secondary dendrite arm spacing and nano-sized dispersoids during homogenization of Al-Zn-Cu-Mg-Zr alloys has been studied. A comprehensive model that can predict…
Various phenomena (phase transformations, chemical reactions, and friction) under high pressures in diamond anvil cell are strongly affected by fields of all components of stress and plastic strain tensors. However, they could not be…
The internal energy associated with the defect microstructure of strongly deformed crystals provides an important driving force for grain boundary motion during recrystallization. Typical dislocation microstructures are strongly…
The mechanism of the evolution of the deformed microstructure at the earliest stage of annealing where the existence of the lowest length scale substructure paves the way to the formation of the so-called subgrains, has been studied for the…
Plastic strain-induced phase transformations (PTs) and chemical reactions under high pressure are broadly spread in modern technologies, friction and wear, geophysics, and astrogeology. However, because of very heterogeneous fields of…
Crystal plasticity of sub-micron finite volumes is characterized by the flow of emergent dislocation defects, giving rise to size effects in mechanical properties and avalanche phenomena. In this chapter, we present a minimal model for…
Within the framework of Landau-Ginzburg theory the kinetics of domain structure formation in ferroelectrics that undergo first order phase transition was investigated under the influence of hydrostatic pressure. It was established that…
Severe plastic deformations under high pressure are used to produce nanostructured materials but were studied ex-situ. We introduce rough diamond anvils to reach maximum friction equal to yield strength in shear and perform the first…
The present article proposes a detailed study of recrystallization of zircaloy-4 under hot forming conditions by means of experimental and numerical tools. Thermomechanical tests and characterization campaigns that have been necessary for…
We present an original approach for predicting the static recrystallization texture development during annealing of deformed crystalline materials. The microstructure is considered as a population of subgrains and grains whose sizes and…
When stressed sufficiently, solid materials yield and deform plastically via reorganization of microscopic constituents. Indeed, it is possible to alter the micro-structure of materials by judicious application of stress, an empirical pro-…
In order to improve the understanding of damage evolution in mechanically heterogeneous microstructures, like the ones of dual-phase steels, the influence of the applied stress state is a key element. In this work, we studied the influence…