相关论文: Flow Characteristics of Elastically Mounted Slit C…
The present study investigates the passive flow control phenomena over a two-dimensional circular cylinder using numerical simulations in the laminar regime. The aim is to explore one of the passive control techniques, which involves the…
The study numerically investigates the three-dimensionality in the flow and two-degree-of-freedom (2 DOF) vortex-induced-vibrations (VIV) characteristics of an elastically mounted circular cylinder. The cylinder is allowed to vibrate in…
Vortex-Induced Vibrations (VIV) offer a safe, renewable, and environmentally friendly energy source for energy harvesting. To enhance the energy harvesting capability of the circular cylinder-based devices, the authors explore the placement…
The present article aims to study the suppression of vortex shedding using a passive flow control technique (slit through a circular cylinder) in the laminar regime (Re=100-500). The slit width ratio S/D (slit width/diameter) on the…
Two-dimensional numerical simulations have been performed to understand the effect of wall proximity on the vortex-induced vibrations (VIV) of an elastically mounted circular cylinder having two degrees of freedom for gap ratios g/D =…
In this work, the coupled dynamics of the gap flow and the vortex-induced vibration (VIV) on a side-by-side (SBS) arrangement of two circular cylinders is numerically investigated at moderate Reynolds number 100 < Re < 800. Of particular…
This paper numerically investigates the influence of a fixed downstream control cylinder on the flow-induced vibration of an elastically-supported primary cylinder. These two cylinders are situated in a tandem arrangement with small…
This study numerically investigates the influence of the taper on the flow-induced vibrations of an elastically mounted circular cylinder under Vortex-induced vibrations. The dynamic response of three different taper ratios defined as 12…
Numerical simulations are conducted to analyze flow characteristics around two tandem sharp-edged cylinders with cross sections of square (b*1 = 1) for the upstream cylinder and rectangle (b*2) for the downstream cylinder (b* = b/a, where a…
Flow-Induced Vibrations (FIV) of an elastically mounted circular cylinder are investigated by means of two-dimensional simulations. A mechanical coupling between cross-flow translation and rotation provides a single degree-of-freedom system…
We study numerically the two-dimensional flow past a circular cylinder as a prototypical transitional flow, and investigate the influence of a generic slip boundary condition on the wake dynamics. We show that slip significantly delays the…
A simple method to increase the flow power extraction efficiency of a circular cylinder, undergoing vortex-induced vibration (VIV), by confining it between two parallel plates is proposed. A two-dimensional numerical study was performed on…
The combined effect of fluid elasticity and yield-stress on the flow past a circular cylinder is studied by two-dimensional direct numerical simulation. We analyze the effects of yield-stress, elasticity, shear-thinning, and…
The hydrodynamic and thermal characteristics of a freely-vibrating circular cylinder in mixed convection flow are numerically investigated at low Reynolds numbers. The numerical investigations are conducted for a range of parameters, Ur =…
Numerical simulation results in recent years show that vortex-induced vibration (VIV) can occur at a subcritical Reynolds number. And the VIV has been observed numerically at Reynolds numbers as low as Re = 20. The current study presents an…
Direct numerical simulation is performed to study compressible, viscous flow around a circular cylinder. The present study considers two-dimensional, shock-free continuum flow by varying the Reynolds number between 20 and 100 and the…
The focus of this work is to dissect the physical mechanisms that drive and sustain flow-induced, transverse vibrations of cylinders. The influence of different mechanisms is quantified by using a method to partition the fluid dynamic force…
In this paper, the TR-PIV method is used to study the internal flow field characteristics in U-shaped channels. The Reynolds number, based on the square cross section channel hydraulic diameter is 8888,13333 and 17777. Mean flow, Reynolds…
We perform direct numerical simulations of flows over finite-aspect-ratio rotating circular cylinders at a Reynolds number of 150 over a range of aspect ratios ($AR=2-12$) and rotation rates ($\alpha=0-5$), aiming at revealing the free-end…
The influence of confinement on the drag force $F$ on a static cylinder in a viscous flow inside a rectangular slit of aperture $h_0$ has been investigated from experimental measurements and numerical simulations. At low enough Reynolds…