相关论文: Precise surface temperature measurements at kHz-ra…
Ferroelectric domain wall devices offer a promising route to low-voltage, reconfigurable nanoelectronics by confining currents to nanoscale conducting interfaces within an insulating bulk. However, the potential for resistive heating and…
This paper presents an experimental methodology to measure the height of the flame using convolution image processing and statistical analysis. The experimental setup employs a burner with four circularly arranged nozzles. Six different…
We report on the calibration of a superfluid $^3$He bolometer developed for the search of non-baryonic Dark Matter. Precise thermometry is achieved by the direct measurement of thermal excitations using Vibrating Wire Resonators (VWRs). The…
We combine a wide variety of experimental techniques to analyze two heretofore mysterious phase transitions in multiferroic bismuth ferrite at low temperature. Raman spectroscopy, resonant ultrasound spectroscopy, EPR, X-ray lattice…
A smartphone fluorimeter capable of time-based fluorescence intensity measurements at various temperatures is reported. Excitation is provided by an integrated UV LED (370 nm) and detection obtained using the in-built CMOS camera. A Peltier…
Phosphorus diffusion on a Si(100) surface was studied using scanning tunneling microscopy (STM) at temperatures of 77 and 300 K. The phosphorus source utilized was the PBr$_3$ molecule, which fully dissociates on the surface at 77 K. We…
Maintaining a comfortable temperature inside a building requires appropriate thermal insulation of windows, which can be optimised iteratively with numerical simulation. Smoothed particle hydrodynamics(SPH) is a fully Lagrangian method…
The reliable measurement and accurate control of the temperature within nanophotonic devices is a key prerequisite for their application in both classical and quantum technologies. Established approaches use sensors that are attached in…
The development of high-performing sensing materials, able to detect ppb-trace concentrations of volatile organic compounds at low temperatures, is required for the development of next-generation miniaturized wireless sensors. Here, we…
Photon detection with quantum-level sensitivity is particularly challenging in the terahertz regime (0.1-10 THz), which contains ~98% of all the photons existing in the universe. Near-quantum-limited terahertz spectrometry has so far only…
High light collection efficiency is an important requirement in any application of scintillation detectors. The purpose of this study is to investigate the possibility for improving this parameter in cryogenic scintillation bolometers,…
Accurate direct measurements of far-field thermal infrared emission become increasingly important because conventional methods, relying on indirect assessments, such as reflectance/transmittance, are inaccurate or even unfeasible to…
A new analysis method has been developed for measurements of broadband, low-amplitude turbulent electron temperature fluctuations in fusion plasmas using individual radiometer channels of a Correlation Electron Cyclotron Emission (CECE)…
The design of low temperature bolometric detectors for rare event searches necessitates careful selection and characterization of structural materials based on their thermal properties. We measure the thermal conductivities of…
The use of cryogenic silicon as a detector medium for dark matter searches is gaining popularity. Many of these searches are highly dependent on the value of the photoelectric absorption cross section of silicon at low temperatures,…
Scanning Thermal Microscopy (SThM) has become an important measurement tool for characterizing the thermal properties of materials at the nanometer scale. This technique requires a SThM probe that combines an Atomic Force Microscopy (AFM)…
This work presents ThermoMesh, a passive thin-film thermoelectric mesh sensor designed to detect and characterize spatio-temporally sparse heat sources through conduction-based thermal imaging. The device integrates thermoelectric junctions…
Wavelength discriminating systems typically consist of heavy benchtop-based instruments, comprising diffractive optics, moving parts, and adjacent detectors. For simple wavelengths measurements, such as lab-on-chip light source calibration…
A novel photonic thermal diode concept operating in the near field and capitalizing on the temperature-dependence of coupled surface polariton modes in nanostructures is proposed. The diode concept utilizes terminals made of the same…
A three-way coupled thermo-mechanical fracture model is presented to predict the damage of brittle ceramics, in particular {\alpha}-SiC, over a wide range of temperatures (20-1400 C). Predicting damage over such a range of temperatures is…