相关论文: Closed-Loop Wireless Power Transfer with Adaptive …

In the sixth-generation (6G) networks, massive low-power devices are expected to sense environment and deliver tremendous data. To enhance the radio resource efficiency, the integrated sensing and communication (ISAC) technique exploits the…

The main objective of this paper is to analyze a closed-loop feedback system where a transmitter probes a discrete memoryless channel (DMC) and can adapt its inputs based on the previous channel outputs. We prove that, regardless of the…

Traditional wireless power transfer (WPT) systems are largely limited to 1-D charging pads or 2-D charging surfaces and therefore do not support a truly ubiquitous device-powering experience. Although room-scale WPT based on multimode…

Wireless power transfer (WPT) is a promising new solution to provide convenient and perpetual energy supplies to wireless networks. In practice, WPT is implementable by various technologies such as inductive coupling, magnetic resonate…

The explosion of the number of low-power devices in the next decades calls for a re-thinking of wireless network design, namely, unifying wireless transmission of information and power so as to make the best use of the RF spectrum,…

Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…

Feedback of quantized channel state information (CSI), called limited feedback, enables transmit beamforming in multiple-input-multiple-output (MIMO) wireless systems with a small amount of overhead. Due to its efficiency, beamforming with…

Energy efficiency has emerged as a critical challenge in modern base stations (BSs), as the power amplifier (PA) consumes a substantial portion of the total power due to its limited efficiency. We investigate waveform and mode adaptation to…

To provide multimode sensory feedback and motion control, bidirectional bionic interfaces for advanced prosthetic systems require continuous and secure energy delivery to implantable electronics and integration in the sensing WBAN (Wireless…

This paper investigates a multi-input single-output (MISO) wireless powered communication network (WPCN) under the protocol of harvest-then-transmit. The power station (PS) with reliable power supply can replenish the passive user nodes by…

This abstract describes the first public demonstration of feedback control and coordination of multiple physical systems over a dynamic multi-hop low-power wireless network with update intervals of tens of milliseconds. Our running system…

Unmanned aerial vehicle (UAV)-enabled wireless power transfer (WPT) has recently emerged as a promising technique to provide sustainable energy supply for widely distributed low-power ground devices (GDs) in large-scale wireless networks.…

Radio frequency (RF) wireless energy transfer (WET) is a promising technology for powering the growing ecosystem of Internet of Things (IoT) using power beacons (PBs). Recent research focuses on efficient PB architectures that can support…

The powering range of wireless power transfer (WPT) systems is typically confined to areas close to the transmitter. Shape-reconfigurable two-dimensional (2-D) relay resonator arrays have been developed to extend this range, offering…

Wireless power transfer (WPT) technologies are becoming ubiquitous, but unlike wire technologies, they do not allow efficient energy transfer through barely transparent barriers. The proposed solutions to this issue rely on resonantly…

Wireless power transfer (WPT) has been an active topic of research, with a number of WPT schemes implemented in the near-field (coupling) and far-field (radiation) regimes. Here, we consider a beamed WPT scheme based on a dynamically…

A single-switch-regulated wireless power transfer (WPT) receiver is presented in this letter. Aiming at low-cost applications, the system involves only a single-switch class-E resonant rectifier, a frequency synchronization circuit, and a…

Low-power sensors can be integrated into an aircraft for numerous use cases. Conventionally, these sensors are powered via cables, which introduces various disadvantages to the overall efficiency of the aircraft. Alternatively, batteries…

In this paper, we propose a joint beamforming algorithm for a multiuser wireless information and power transfer (MU-WIPT) system that is compatible with the conventional multiuser multiple input multiple output (MU-MIMO) system. The…

In this paper, we study the average throughput performance of energy beamforming in a multi-antenna wireless-powered communication network (WPCN). The considered network consists of one hybrid access-point (AP) with multiple antennas and a…