相关论文: Theory-based scaling laws of near and far scrape-o…
The scrape-off layer parallel heat flux decay lengths measured at ST40, a high field, low aspect ratio spherical tokamak, have been observed to bifurcate into two groups. The wide group matches closely with the scale of ion poloidal Larmour…
The narrow power decay-length ($\lambda_q$), recently found in the scrape-off layer (SOL) of inner-wall limited (IWL) discharges in tokamaks, is studied using 3D, flux-driven, global two-fluid turbulence simulations. The formation of the…
Tokamak edge (scrape-off layer) plasmas can exhibit non-local transport in the direction parallel to the magnetic field due to steep temperature gradients. This effect along with its consequences has been explored at equilibrium for a range…
The scrape-off layer (SOL) power width (\lambda_q) is important for predicting the heat load on divertor targets for future magnetically confined devices. Currently, the underlying physics for \lambda_q scaling is not fully understood. This…
The scaling of scrape-off layer (SOL) power width ({\lambda}q) is essential for advancing the understanding of particle and heat transport in the SOL. Due to the sparse layout of divertor Langmuir probes (Div-LPs) and probe erosion during…
Plasma facing components (PFCs) in the next generation of tokamak devices will operate in challenging environments, with heat loads predicted to exceed 10 MWm$^{-2}$. The magnitude of these heat loads is set by the width of the channel, the…
Two dimensional stochastic time model of scrape-off layer (SOL) turbulent transport is studied. Instability arisen in the system with respect to the stochastic perturbations of both either density or vorticity reveals itself in the strong…
The propagation of filaments in the Scrape Off Layer (SOL) of tokamaks largely determine the plasma profiles in the region. In a conduction limited SOL, parallel temperature gradients are expected, such that the resistance to parallel…
Typically, fluid simulations are used for tokamak divertor design. However, fluid models are only valid if the SOL is highly collisional, an assumption that is valid in many present day experiments but is questionable in the high-power…
In this work we carry out quantitative measurements of particle and heat transport associated to SOL filaments in a tokamak, and relate density shoulder formation to the advection of energy in the far SOL. For the first time, this attempt…
The power load to the divertor surfaces is a key concern for future devices such as ITER, due to the thermal limits on the material surface. One factor that characterizes the heat flux to the divertor is the fall off length in the…
Studying the process of divertor detachment and the associated complex interplay of plasma dynamics and atomic physics processes is of utmost importance for future fusion reactors. Whilst simplified analytical models exist to interpret the…
The effect of triangularity on tokamak boundary plasma turbulence is investigated by using global, flux-driven, three-dimensional, two-fluid simulations. The simulations show that negative triangularity stabilizes boundary plasma…
Understanding of the scrape-off layer (SOL) physics in tokamaks requires diagnostics with sufficient temporal and spatial resolution. This contribution describes results of experiments performed in the SOL of the CASTOR tokamak (R=40 cm, a…
There exists a large body of previous work using reduced two-dimensional models of the SOL, which model fluctuations in the drift-plane but approximate parallel transport with effective loss terms. Full size three-dimensional simulations of…
Radial profiles of the ion saturation current and its fluctuation statistics are presented from probe measurements in L-mode, neutral beam heated plasmas at the outboard mid-plane region of KSTAR. The familiar two-layer structure, seen…
The SOL width is a parameter of paramount importance in modern tokamaks as it controls the power density deposited at the divertor plates, critical for plasma-facing material survivability. An understanding of the parameters controlling it…
The results of flux-driven, two-fluid simulations in single-null configurations are used to investigate the processes determining the turbulent transport in the tokamak edge. Three turbulent transport regimes are identified: (i) a developed…
The dynamic interplay between the core and the edge plasma has important consequences in the confinement and heating of fusion plasma. The transport of the Scrape-Off-Layer (SOL) plasma imposes boundary conditions on the core plasma, and…
This paper presents a numerical investigation of isolated filament dynamics in a simulation geometry representative of the scrape-off layer (SOL) of the Mega Amp Spherical Tokamak (MAST) previously studied in [N.R.Walkden et.al, Plasma…