相关论文: Carbon Paste Electrode Modified Poly-Glutamic Acid…

In this letter we show the inclusion of Rhodamine B molecules (RhB) inside a dielectric-loaded surface plasmon waveguide enables for a precise determination of its optical characteristics. The principle relies on the coupling of the…

Raman intensity of Rhodamine B (RhB) is enhanced by inserting a thin high \k{appa} dielectric layer which reduces the surface plasmon damping at the gold-graphene interface. The results indicate that the Raman intensity increases sharply by…

Recognition and determination of paraquat (PQ) using graphite pencil electrode (GPE) modified with polypyrrole (Ppy) doped with Eriochrome blue-black B (EBB) is reported. To that end, a thin film of Ppy was deposited onto the electrode…

Graphene, a two-dimensional monolayer of sp2-bonded carbon atoms in a honeycomb lattice, possesses exceptional electronic, mechanical, and quantum properties, making it highly attractive for energy storage, spintronics, and…

Advance designs of random lasers towards development of miniature laser systems are in demand. We demonstrated random lasing from Rhodamine-B dye attached to polystyrene micro-spheres. Bare polystyrene spheres were used as scatterers and…

Local environment of fluorescent dyes could strongly affect emission dynamics of the latter. In particular, both signal intensities and emission lifetimes are highly sensitive to solvent temperatures. Here, temperature-dependent behavior…

We demonstrate electrochemical top gating of graphene by using a solid polymer electrolyte. This allows to reach much higher electron and hole doping than standard back gating. In-situ Raman measurements monitor the doping. The G peak…

Pristine polycrystalline boron-doped diamond electrodes (BDDEs) -- microcrystalline (B-MCDE) and ultrananocrystalline (B-UNCDE) were applied for the electrochemical reduction of several selected purine nucleotides -- Guanosine…

Graphene-based sponges doped with atomic nitrogen and boron were applied for the electrochemical degradation of persistent organic contaminants in one-pass, flow-through mode, and in a low-conductivity supporting electrolyte. The B-doped…

We report observation of anisotropic surface plasmon-coupled emission (SPCE) from structured PMMA films doped with Rhodamine B (RhB) and deposited on silver films. For a given structure, it is observed that relative position of incident…

Highly controlled coating of biomimetic polydopamine (PDA) was achieved on titanium dioxide nanotubes (TiO2 NTs) by exposing TiO2 NT arrays to a slightly alkaline dopamine solution. The thin films act as photonic sensitizers (enhancing…

Printed circuit boards (PCBs) are widely used in most electrical and electronic equipments or products. Hazardous substances such as Pb, Hg, Cd, etc, can be present in high concentrations in PCBs and the degradation and release of these…

Point Projection Microscopy (PPM) is used to image suspended graphene using low-energy electrons (100-200eV). Because of the low energies used, the graphene is neither damaged or contaminated by the electron beam. The transparency of…

Heavy metal pollution is a severe environmental problem affecting many water resources. The non-biodegradable nature of the heavy metals such as lead (Pb) causes severe human health issues, so their cost-effective, sensitive and rapid…

The copolymerization of melamine with 2,4,6-triaminopyrimidine (TAP) in an electrochemical induced polymerization process leads to the formation of molecular doped poly (triazine imide) (PTI). The polymerization is based on the electrolysis…

Raman Spectroscopy offers an in-situ, rapid, and non-destructive characterization tool for chemical analysis of diverse samples with no or minimal preparation. However, due to the inherent weak signal of conventional Raman spectroscopy,…

Variation in fluorescence intensity from rhodamine 6G dye was investigated. A small volume of dye solution was optically excited with a 0.4 mW, 532nm wavelength cw-laser light. The dye was dissolved in methanol and glycerol for a…

Objective: Bioimpedance measurements are mostly performed utilizing gel electrodes to decrease the occurring electrode-skin impedance. Since in many measurement environments this kind of electrode is not appropriate, the usability of dry…

This paper discusses the latest progress in the development of GRAPE (Gamma-Ray Polarimeter Experiment), a hard X-ray Compton Polarimeter. The purpose of GRAPE is to measure the polarization of hard X-rays in the 50-300 keV energy range. We…

In this work an electron radiation detector microdevices were fabricated and characterized. The devices consisted of a conductive electrospun mat made of polycaprolactone loaded with multiwalled carbon nanotubes and fullerene C60 deposited…