相关论文: Hybrid Beamforming for mm-Wave Massive MIMO System…

Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…

Microwave linear analog computing (MiLAC) has recently emerged as a promising architecture for analog-domain beamforming. In particular, a hybrid digital-MiLAC architecture was proposed and was shown to achieve fully-digital beamforming…

In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…

Hybrid beamforming is widely recognized as an important technique for millimeter wave (mmWave) multiple input multiple output (MIMO) systems. Generalized spatial modulation (GSM) is further introduced to improve the spectrum efficiency.…

This paper proposed new hybrid, analog-digital, beamforming for a multiuser millimeter wave (mm-wave) relay system. For this system, we consider a sum rate maximization problem. The proposed hybrid beamforming is designed indirectly by…

To circumvent the high path loss of mmWave propagation and reduce the hardware cost of massive multiple-input multiple-output antenna systems, full-dimensional hybrid beamforming is critical in 5G and beyond wireless communications.…

In this paper, we study the channel estimation problem in correlated massive multiple-input-multiple-output (MIMO) systems with a reduced number of radio-frequency (RF) chains. Importantly, other than the knowledge of channel correlation…

As communication systems that employ millimeter wave (mmWave) frequency bands must use large antenna arrays to overcome the severe propagation loss of mmWave signals, hybrid beamforming has been considered as an integral component of mmWave…

This paper proposes a hybrid beamforming framework for massive multiple-input multiple-output (MIMO) in near-space airship-borne communications. To achieve high energy efficiency (EE) in energy-constraint airships, a dynamic subarray…

Massive multiple-input multiple-output (MIMO) avails of simple transceiver design which can tackle many drawbacks of relay systems in terms of complicated signal processing, latency, and noise amplification. However, the cost and circuit…

Switch-based hybrid beamforming (SW-HBF) architectures are promising for realizing massive multiple-input multiple-output (MIMO) communications systems because of their low cost and low power consumption. In this paper, we study the…

Hybrid beamforming is vital in modern wireless systems, especially for massive MIMO and millimeter-wave (mmWave) deployments, offering efficient directional transmission with reduced hardware complexity. However, effective beamforming in…

Hybrid analog and digital beamforming transceivers are instrumental in addressing the challenge of expensive hardware and high training overheads in the next generation millimeter-wave (mm-Wave) massive MIMO (multiple-input multiple-output)…

This paper focuses on multiuser MIMO channel estimation and data transmission at millimeter wave (mmWave) frequencies. The proposed approach relies on the time-division-duplex (TDD) protocol and is based on two distinct phases. First of…

The wide bandwidths offered at millimeter-wave (mmWave) frequencies have made them an attractive choice for future wireless communication systems. Recent works have presented beamforming strategies for enabling in-band full-duplex (FD)…

Modern wireless communication networks, particularly cellular networks utilize multiple antennas to improve the capacity and signal coverage. In these systems, typically an active transceiver is connected to each antenna. However, this…

Analog Beamsteering (ABS) has emerged as a low complexity, power efficient solution for MillimeterWave (mmWave) massive Multiple Input Multiple Output (MIMO) systems. Moreover, driven by the low spatial correlation between the User…

This study employs a uniform rectangular array (URA) sub-connected hybrid beamforming (SC-HBF) architecture to provide a novel self-interference (SI) suppression scheme in a full-duplex (FD) massive multiple-input multiple-output (mMIMO)…

A wireless network serving multiple users in the millimeter-wave or the sub-terahertz band by a base station is considered. High-throughput multi-user hybrid-transmit beamforming is conceived by maximizing the minimum rate of the users. For…

Future wireless communications will rely on multiple-input multiple-output (MIMO) beamforming operating at millimeter wave (mmWave) frequency bands to deliver high data rates. To support flexible spatial processing and meet the demands of…