相关论文: Design and Simulation of a Steam Turbine Generator…
This paper introduces a smart model for intelligent energy management of steam generators which are utilized for steam generator and controlling the air to fuel ratio for steam generator all over the firing curve and transient mode…
In this paper, an approach for active power control of individual wind turbines is presented. State-of-the-art controllers typically employ separate control loops for torque and pitch control. In contrast, we use a multivariable control…
In this paper a NARMA L2, model reference and neural network predictive controller is utilized in order to control the output flow rate of the steam in furnace by controlling the steam flow valve. The steam flow control system is basically…
This work presents a hierarchical architecture for the optimal management of an ensemble of steam generators, which needs to jointly sustain a common load. The coordination of independent subsystems is provided by a multi-layer control…
A hierarchical architecture for the optimal management of an ensemble of steam generators is presented. The subsystems are coordinated by a multilayer scheme for jointly sustaining a common load. The high level optimizes the load allocation…
Researchers have extensively explored predictive control strategies for controlling heating, ventilation, and air conditioning (HVAC) units in commercial buildings. Predictive control strategies, however, critically rely on weather and…
Solid-state thermionic power generators are an alternative to thermoelectric modules. In this manuscript, we develop an analytical model to investigate the performance of these generators in the non-linear regime. We identify dimensionless…
This paper presents a laboratory setup usable for the design and testing of a Wind Energy Conversion System respectively their control solutions. The stand can be used for research or in the engineering educational system offering the…
This paper presents a novel fault-tolerant control framework for steam temperature regulation in Heat Recovery Steam Generators (HRSGs) subject to actuator faults. Addressing the critical challenge of valve degradation in superheater spray…
In wind farms, wake interaction leads to losses in power capture and accelerated structural degradation when compared to freestanding turbines. One method to reduce wake losses is by misaligning the rotor with the incoming flow using its…
This paper presents a closed-loop controller for wind farms to provide active power control services using a high-fidelity computational fluid dynamics based wind plant simulator. The proposed design enhances power tracking stability and…
Turbines are essential components of jet planes and power plants. Therefore, their efficiency and service life are of central engineering interest. In the case of jet planes or thermal power plants, the heating of the turbines due to the…
A quantum thermal transistor is designed by the strong coupling between one qubit and one qutrit which are in contact with three heat baths with different temperatures. The thermal behavior is analyzed based on the master equation by both…
This paper presents a comparative analysis of several modelling approaches of key elements used in simulations of power systems with renewable energy sources. Different models of synchronous generators, transmission lines, converters, wind…
A wind turbine works with the principle of extracting energy from the wind to generate electricity. The power generated is directly proportional to the wind speed available. There are two major types of wind turbine design namely the…
This chapter provides an introduction to the modeling and control of power generation from wind turbine systems. In modeling, the focus is on the electrical components: electrical machine (e.g. permanent-magnet synchronous generators),…
This paper presents an open source Simulink based program developed for simulating power systems integrated with renewable energy sources (RES). The generic model of a photovoltaic, wind turbine, and battery energy storage is used for the…
The Application of Bio Inspired Algorithms to complicated Power System Stability Problems has recently attracted the researchers in the field of Artificial Intelligence. Low frequency oscillations after a disturbance in a Power system, if…
Thermoelectric power generators are used to convert heat into electricity. Like any other heat engine, the performance of a thermoelectric generator increases as the temperature difference on the sides increases. It is generally assumed…
Control co-design (CCD) explores physical and control design spaces simultaneously to optimize a system's performance. A commonly used CCD framework aims to achieve open-loop optimal control (OLOC) trajectory while optimizing the physical…