相关论文: High temperature strength retention of Cu/Nb nanol…
We report on a novel approach to dynamic compression of materials that bridges the gap between previous static- and dynamic- compression techniques, allowing to explore a wide range of pathways in the pressure-temperature space. By…
Dynamic recrystallization (DRX) is often observed in conjunction with adiabatic shear banding (ASB) in polycrystalline materials. The recrystallized nanograins in the shear band have few dislocations compared to the material outside of the…
MgB2 thin films were deposited on SiC buffered Si substrates by sequential electron beam evaporation of B-Mg bilayer followed by in-situ annealing. The application of a SiC buffer layer enables the maximum annealing temperature of 830 C.…
Amorphous complexions in nanocrystalline metals have the potential to improve mechanical properties and radiation tolerance, as well as resistance to grain growth. In this study, the stability of amorphous complexions in binary and ternary…
The thermophysical properties of supported and free-standing nanomaterials would be different due to the substrate effect. To determine the thermophysical properties of supported 2D nanomaterials, this paper developed a two-step…
The fatigue properties of 930 nm-thick Au films and 1 {\mu}m-thick Au film with a Ti interlayer are systematically investigated. The dominant damage behaviors of 930 nm-thick Au films under dynamic bending cyclic loading changed from…
This investigation has used flexural test to explore the effects of thermal treatments, i.e., high-temperature and cryogenic environments on the mechanical property of alumina particulate-reinforced Cu metal matrix micro and nanocomposites…
Understanding nanomechanical response of materials represents a scientific challenge. Here, we have used in-situ electron microscopy to reveal drastic for the first time changes of structural behavior during deformation of 1-nm-wide metal…
We investigated the influence of doping antiferromagnetic MnN in polycrystalline MnN/CoFe exchange bias systems, showing high exchange bias of up to 1800 Oe at room temperature. The thermal stability of those systems is limited by nitrogen…
The study of materials behavior under extreme conditions is fundamental to science and modern technology. Fast ramp compression is a unique method for exploring materials behavior and phase transformations under extreme conditions. One…
Surface strain is widely used in gas phase catalysis and electrocatalysis to control the binding energies of adsorbates on metal surfaces. However, $in$ $situ$ or $operando$ strain measurements are experimentally challenging, especially on…
A combination of high strength and reasonable ductility has been achieved in a copper-1.7 at.%titanium alloy deformed by high-pressure torsion. Grain refinement and a spinodal microstructure provided a hardness of 254 +/- 2 HV , yield…
Iron oxide nano particles with nominal Fe2O3 stoichiometry were synthesized by a wet, soft chemical method with the heat treatment temperatures from 250{\deg}C to 900{\deg}C in air. The variation in the structural properties of the nano…
Nanodot deposition on a side surface of a rectangular sample and digital image correlation are used to quantify the in-plane strain fields associated with the propagation of a shear band in a PdNiP bulk metallic glass,induced by rolling.…
The mechanisms that govern a previously unexplained hardening effect of a single phase Cu-30wt%Zn {\alpha}-brass after heating have been investigated. After cold-work, the alloy possesses an increased yield strength and hardening rate only…
Most mechanical resonators are treated as simple linear oscillators. Nonlinearity in the resonance behavior of nanoelectromechanical systems (NEMS) has only lately attracted significant interest. Most recently, cubic-order nonlinearity has…
The mechanical response of Haynes 282, a wrought gamma prime strengthened nickel based superalloy, is tailored by using both a cold deformation processing and a post straining heat treatment including a two step aging. In this work, the…
We use elastomeric polydimethylsiloxane substrates to strain single-walled carbon nanotubes and modulate their electronic properties, with the aim of developing flexible materials that can sense local strain. We demonstrate micron-scale…
The dewetting of thin nanofilms is significantly impacted by thermal fluctuations, liquid-solid slip, and disjoining pressure, which can be described by lubrication equations augmented by appropriately scaled noise terms, known as…
Crystallization pressure drives deformation and damage in monuments, buildings and the Earth's crust. Even though the phenomenon has been known for 170 years there is no agreement between theoretical calculations of the maximum attainable…