相关论文: High temperature strength retention of Cu/Nb nanol…
The statistical-thermodynamic dislocation theory developed in previous papers is used here in an analysis of high-temperature deformation of aluminum and steel. Using physics-based parameters that we expect theoretically to be independent…
The magnetic properties and magnetization dynamics of polycrystalline ultra-thin Co layers were investigated using a broadband ferromagnetic resonance (FMR) technique at room temperature. A variable thickness (1 nm $\leq t \leq$ 10 nm) Co…
Post deposition variation in film resistance of Sb2Te3 films deposited on glass substrates at room temperature and an elevated temperature (110oC) are investigated. The resistance of films grown at room temperature shows a non-linear…
Molecular dynamics (MD) simulations have been performed to investigate the fatigue deformation behaviour of polycrystalline Cu with grain size of 5.4 nm. The samples were prepared using Voronoi algorithm with random grain orientations.…
Niobium is commonly used for superconducting quantum systems as readout resonators, capacitors, and interconnects. The coherence time of the superconducting qubits is mainly limited by microwave dissipation attributed to two-level system…
Nb3Sn and V3Si thin films are promising candidates as thin films for the next generation of superconducting radio-frequency (SRF) cavities. However, sputtered films often suffer from stoichiometry and strain issues during deposition and…
The wear-driven structural evolution of nanocrystalline Cu was simulated with molecular dynamics under constant normal loads, followed by a quantitative analysis. While the microstructure far away from the sliding contact remains unchanged,…
The influence of pre-strain and temperature on the superior properties exhibited by an Nb nanowire embedded in a NiTi shape memory alloy (SMA) are investigated via molecular dynamics simulations. To this end, a new Nb-Ni-Ti ternary…
The nonlinear mechanical response of carbon nanotubes, referred to as their "buckling" behavior, is a major topic in the nanotube research community. Buckling means a deformation process in which a large strain beyond a threshold causes an…
Characterizing plasticity mechanisms below the ductile-to-brittle transition temperature is traditionally difficult to accomplish in asystematic fashion. Here, we use a new experimental setup to perform in situ cryogenic mechanical testing…
A general self-learning metabasin escape (SLME) algorithm~\citep{caoPRE2012} is coupled in this work with continuous shear deformations to probe the yield stress as a function of strain rate and temperature for a binary Lennard-Jones (LJ)…
In the rapidly evolving field of quantum computing, niobium nitride (NbN) superconductors have emerged as integral components due to their unique structural properties, including a high superconducting transition temperature (Tc),…
NiO is a promising p-type material for photovoltaics and power electronics, but its temperature limits remain unclear. Using in situ high-temperature X-ray diffraction (HT-XRD) from 30 to 1100 C, we track the structural evolution of NiO…
Superconducting Nb3Sn films can be synthesized by controlling the atomic concentration of Sn. Multilayer sequential sputtering of Nb and Sn thin films followed by high temperature annealing is considered as a method to fabricate Nb3Sn…
We present in this paper the structural and magnetic properties of high aspect ratio Co nanoparticles (~10) at high temperatures (up to 623 K) using in situ X ray diffraction (XRD) and SQUID characterizations. We show that the anisotropic…
Recently, Nb superconducting radio frequency cavities vacuum heat treated between 300-400 C for a few hours have exhibited very high quality factors (~5x10^10 at 2.0 K). New secondary ion mass spectrometry measurements of O, N and C show…
The nanocrystalline-amorphous textures are commonly observed in the coatings synthesized by energetic deposition.This work reports a theoretical study towards binary Cu-C phase separation.By performing a MD simulation using the LAMMPS…
We present a mm-scale optical fiber strain sensor to continuously measure the food deformation below the surface during the drying process. The sensor has a soft buffer sleeve, which enables a large measurable deformation range and…
Solute segregation is used to limit grain growth in nanocrystalline metals, but this stabilization often breaks down at high temperatures. Amorphous intergranular films can form in certain alloys at sufficiently high temperatures, providing…
One of many challenges for niobium (Nb) based superconducting devices is the improvement over the surface morphology and superconducting properties as well as the reduction of defects. We employed a novel deposition technique, i.e. biased…