相关论文: Beyond Quality and Quantity: Contact Distribution …
We calculate the van der Waals friction between two semi-infinite solids in normal relative motion and find a drastic difference in comparison with the parallel relative motion. The case of the good conductors is investigated in details…
The evolution of fractal surface structures with flattening of asperities was investigated using isotropically roughened aluminium surfaces loaded in compression. It was found that asperity amplitude, mean roughness and fractal dimension…
The friction force, friction coefficients and the effects on the dynamics of particles, bodies and systems, are fundamental themes in university physics of the first cycles and also in general physics courses of upper secondary education in…
We investigate numerically a simple microscopic model to describe wearless dry friction between atomically flat contact interfaces without thermal fluctuations (T=0K). The analysis of the incommensurate ground state shows a breaking of…
When two solids are squeezed together they will in general not make atomic contact everywhere within the nominal (or apparent) contact area. This fact has huge practical implications and must be considered in many technological…
Granular materials transmit stress via a network of force chains. Despite the importance of these chains to characterizing the stress state and dynamics of the system, there is no common framework for quantifying their their properties.…
The effect of self-affine roughness on solid contact is examined with molecular dynamics and continuum calculations. The contact area and normal and lateral stiffnesses rise linearly with the applied load, and the load rises exponentially…
Frictional interfaces are abundant in natural and engineering systems, and predicting their behavior still poses challenges of prime scientific and technological importance. At the heart of these challenges lies the inherent coupling…
The results obtained from molecular dynamics simulations of the friction at an interface between polymer melts and weakly attractive crystalline surfaces are reported. We consider a coarse-grained bead-spring model of linear chains with…
We present an experimental investigation of the non stationary frictional properties of multicontact interfaces between rough elastomers and rough hard glass at low velocities (<= 200 mu m s^{-1}). These systems, for which the deformation…
Contact mechanics-based models for the friction of nominally flat rough surfaces have not been able to adequately capture certain key experimentally observed phenomenona, such as the transition from a static friction peak to a lower level…
The influence of out-of-plane oscillations on friction is a well-known phenomenon that has been studied extensively with various experimental methods, e.g. pin-on-disk tribometers. However, existing theoretical models have yet achieved only…
Friction is fundamental to mechanical stability across scales, from geological faults and architectural structures to granular materials and animal feet. We study the mechanical stability of a minimal friction-stabilized structure composed…
The effect of thermal fluctuations near a contact line of a liquid interface partially wetting an impenetrable substrate is studied analytically and numerically. Promoting both the interface profile and the contact line position to random…
A numerical analysis of mechanical frictionless contact between rough self-affine elastic manifolds was carried out. It is shown that the lower cutoff wavenumber in surface spectra is a key parameter controlling the representativity of the…
Using as a starting point conservation of momentum, a multiphase mechanical energy balance equation is derived that accounts for multiple material phases and interfaces present within a moving control volume. This balance is applied to a…
Static mechanical properties (e.g. elastic modulus) and fatigue properties of a material all have dispersions. Material inhomogeneity (it can be characterized well by the dispersion of elastic modulus) is the internal factor of dispersions…
The measurement of real contact area between rough surfaces is one of most challenge problems in contact mechanics and is of importance to understand some physical mechanisms in tribology. Based on the frustrated total internal reflection,…
Liquid wetting of a surface is omnipresent in nature and the advance of micro-fabrication and assembly techniques in recent years offers increasing ability to control this phenomenon. Here, we identify how surface roughness influences the…
Normal contact behaviour between non adhesive fractal rough particles is studied using a finite element method (FEM). A series of spherical grain surfaces with distinguished roughness features are generated by means of Spherical Harmonics.…