相关论文: Deformation upon impact of a concentrated suspensi…
The aerodynamic breakup of a polymeric droplet in the bag breakup regime is investigated experimentally and compared with the result of the Newtonian droplet. To understand the effect of liquid elasticity, the Weber number is kept fixed…
In this chapter, we analyze the steady-state microscale fluid--structure interaction (FSI) between a generalized Newtonian fluid and a hyperelastic tube. Physiological flows, especially in hemodynamics, serve as primary examples of such FSI…
The deformation and break-up of Newtonian/viscoelastic droplets are studied in confined shear flow. Our numerical approach is based on a combination of Lattice-Boltzmann models (LBM) and finite difference schemes, the former used to model…
During detachment of a viscous fluid extruded from a nozzle a filament linking the droplet to the latter is formed. Under the effect of surface tension the filament thins until pinch off and final detachment of the droplet. In this paper we…
The evolution of suspension drops sedimenting under gravity in a viscous fluid close to a vertical wall was studied experimentally and numerically with the use of the point-force model, in the Stokes flow regime. The fluid inside and…
We use interface-resolved simulations to study finite-size effects in turbulent channel flow of neutrally-buoyant spheres. Two cases with particle sizes differing by a factor of 2, at the same solid volume fraction of 20% and bulk Reynolds…
Noneqiuilibrium dynamics of rotating droplets are studied by molecular dynamics simulations. Small deviations from the theoretical prediction are observed when the size of a droplet is small, and the deviations become smaller as the size of…
A three-dimensional, volume-of-fluid (VOF) based CFD model is presented to investigate droplet formation in a microfluidic T-junction. Genesis of Newtonian droplets in non-Newtonian liquid is numerically studied and characterized in three…
Freezing of dispersions is omnipresent in science and technology. While the passing of a freezing front over a solid particle is reasonably understood, this is not so for soft particles. Here, using an oil-in-water emulsion as a model…
The dynamics of drop impact on solid surfaces can be changed significantly by tuning the elasticity of the solid. Most prominently, the substrate deformation causes an increase in the splashing threshold as compared to impact onto perfectly…
The dynamics of a single elastoviscoplastic (EVP) drop immersed in plane shear flow of a Newtonian fluid is studied by 3D direct numerical simulations using a finite-difference and level-set method combined with the Saramito model for the…
Breakup of drop/bubble can be viewed as a result of fundamental force balance when the disruptive force is greater than the restorative force. A disruptive force acting on the drop/bubble tries to deform it, whereas a restorative force…
We investigate freely expanding sheets formed by ultrasoft gel beads, and liquid and viscoelastic drops, produced by the impact of the bead or drop on a silicon wafer covered with a thin layer of liquid nitrogen that suppresses viscous…
The present study explores the impact of a non-Newtonian fluid drop on a rigid surface using a mesh-free approach, Smoothed Particle Hydrodynam-ics. The complex interaction between viscous and elastic forces during drop impact may be…
We investigated the transient relaxation of a Discontinuous Shear Thickening suspension of cornstarch in water. We performed 2 types of relaxation experiments starting from a steady shear in a parallel plate rheometer, followed by either…
The properties of liquid dispersions, such as foams or emulsions, depend strongly on the volume fraction $\phi$ of the continuous phase. Concentrating on the example of foams, we show experimentally and theoretically that $\phi$ may be…
Spilling tea or coffee leads to a tell-tale circular stain after the droplet dries, known as the "coffee ring effect". The evaporation of suspension droplets is a complex physical process, and predicting and controlling the particle deposit…
We study non-local effects associated with particle collisions in dense suspension flows, in the context of the affine solvent model known to capture various aspects of the jamming transition. We show that an individual collision changes…
The maximum spreading of an impacting liquid drop is a key metric for characterizing the fundamental fluid process of drop impact. While extensively studied for Newtonian liquids, how far a non-Newtonian drop can spread upon impacting a…
The impact of nanometer sized drops on solid surfaces is studied using molecular dynamics simulations. Equilibrated floating drops consisting of short chains of Lennard-Jones liquids with adjustable volatility are directed normally onto an…