相关论文: Intensity-Modulated Fiber-Optic Voltage Sensors fo…

Real-time frequency readout of time-dependent pulsed signals with a high sensitivity are key elements in many applications using atomic devices, such as FID atomic magnetometers. In this paper, we propose a frequency measurement algorithm…

We report on the characterization of a commercial-core fiber-based frequency comb equipped with an intracavity electro-optic modulator (EOM). We investigate the relationship between the noise of the pump diode and the laser relative…

We numerically demonstrate a new type of waveform-selective metasurface that senses the difference in incoming waveforms or pulse widths at the same frequency. Importantly, the proposed structure contains precise rectifier circuits that,…

We demonstrate the generation, 40 km fiber transmission, and homodyne detection of single-mode squeezed states of light at 1550 nm using real-time phase control of a locally generated local oscillator, often called a "real local oscillator"…

An inertial sensor design is proposed in this paper to achieve high sensitivity and large dynamic range in the sub-Hz frequency regime. High acceleration sensitivity is obtained by combining optical cavity readout systems with…

In situ tunable photonic filters and memories are important for emerging quantum and classical optics technologies. However, most photonic devices have fixed resonances and bandwidths determined at the time of fabrication. Here we present…

We report on the realization of a high sensitivity RF noise measurement scheme to study small current fluctuations of mesoscopic systems at milliKelvin temperatures. The setup relies on the combination of an interferometric ampli- fication…

A general-purpose all-fiber spectrometer is demonstrated to overcome the trade-off between spectral resolution and bandwidth. By integrating a wavelength division multiplexer with five multimode optical fibers, we have achieved 100 nm…

We propose and demonstrate that a conventional multimode fiber can function as a high resolution, low loss spectrometer. The proposed spectrometer consists only of the fiber and a camera that images the speckle pattern generated by…

Dynamic optical sensors, as those based on the reflectivity of isotropic dielectrical interfaces, can be useful for measuring small changes in the refractive index of fluid media. Exact and approximated explicit formulas for their…

The intrinsic thermal noise in optical fibers is the ultimate limit of fiber-based systems. However, at infrasonic frequencies, the spectral behavior of the intrinsic thermal noise remains unclear so far. We present the measurements of the…

Increasing adoption of smart meters and phasor measurement units (PMUs) in power distribution networks are enabling the adoption of data-driven/model-less control schemes to mitigate grid issues such as over/under voltages and power-flow…

Reduction in the operating voltage of electrooptic modulators is needed in order to remove the bottleneck in the flow of data between electronics and optical interconnects. We report experimental demonstration of a 10 fold reduction in an…

Plasmonic sensing has been in the spotlight for decades, the concept and applications of which have been generalized to spoof surface plasmons (SSPs) in the microwave band. Here, we report a compact and wireless sensor within a printed…

A multimode microcavity sensor based on a self-interference microring resonator is demonstrated experimentally. The proposed multimode sensing method is implemented by recording wideband transmission spectra that consist of multiple…

Here we demonstrate an on-chip electro-optic frequency shifter that is precisely controlled using only a single-tone microwave signal. This is accomplished by engineering the density of states of, and coupling between, optical modes in…

An opto-electronic radio-frequency oscillator that is based on forward scattering by the guided acoustic modes of a standard single-mode optical fiber is proposed and demonstrated. An optical pump wave is used to stimulate narrowband,…

The Internet of Things (IoT) is pivotal in transforming the way we live and interact with our surroundings. To cope with the advancement in technologies, it is vital to acquire accuracy with the speed. A phase frequency detector (PFD) is a…

Intensity modulators are an essential component in optics for controlling free-space beams. Many applications require the intensity of a free-space beam to be modulated at a single frequency, including wide-field lock-in detection for…

Fiber optic sensing is becoming an important means to physically secure today's network infrastructure. However, a network-wide deployment of the monitors will require cost reduction of the interrogator system, which can only be achieved by…