相关论文: Intensity-Modulated Fiber-Optic Voltage Sensors fo…
We propose a novel radio-frequency (RF) receiving architecture based on micro-electro-mechanical system (MEMS) and optical coherent detection module. The architecture converts the received electrical signal into mechanical vibration through…
We propose using THz frequency selective surfaces interrogated with THz subwavelength optical fibers as sensors for monitoring of the optical properties of thick films that are brought in contact with such surfaces. Changes in the test film…
Speckle-based fiber optic sensors are well-known to offer high sensitivity but are strongly limited on the interrogation side by low camera frame rates and dynamic range. To address this limitation, we present a novel interrogation…
Millimeter-wave (mmWave) band (30 - 300 GHz) is an emerging spectrum range for wireless communication, short-range radar and sensor applications. mmWave-optic modulators that could efficiently convert mmWave signals into optical domain are…
Optical cavities provide high sensitivity to dispersion since their resonance frequencies depend on the index of refraction. We present a direct, broadband, and accurate measurement of the modes of a high finesse cavity using an optical…
A novel and simple approach to optical wavelength measurement is presented in this paper. The working principle is demonstrated using a tunable waveguide micro ring resonator and single photodiode. The initial calibration is done with a set…
The development of optical fibers has revolutionized telecommunications by enabling long-distance broad-band transmission with minimal loss. In turn, the ubiquity of high-quality low-cost fibers enabled a number of additional applications,…
Monitoring the optical phase change in a fiber enables a wide range of applications where fast phase variations are induced by acoustic signals or vibrations in general. However, the quality of the estimated fiber response strongly depends…
Waveguide-based interferometric circuits are widely employed in optical communications, sensing and computing applications. In particular, glass-based devices are appealing due to the transparency and bio-compatibility of this substrate, or…
We propose a nonlinear fiber system for shot-noise limited, all-optical intensity-noise reduction and signal amplification. The mechanism is based on the accumulation of different nonlinear phase shifts between orthogonal polarization modes…
We describe an all-fiber nonlinear interferometer based on four-wave mixing in highly nonlinear fiber. Our configuration realizes phase-sensitive interference with 97% peak visibility and >90% visibility over a broad 554 GHz optical band.…
Electro-optic modulators with low voltage and large bandwidth are crucial for both analog and digital communications. Recently, thin-film lithium niobate modulators have enable dramatic performance improvements by reducing the required…
We present a fiber sensor based on an active integrated component which could be effectively used to measure the longitudinal vibration modes of telescope mirrors in an interferometric array. We demonstrate the possibility to measure…
We present a fiber-ring resonator that realizes an ultra-narrowband, high-extinction, low-loss, tunable optical filter. It consists of a pair of commercial variable ratio directional couplers that allow precise adjustment of the filter…
We observe an interference pattern using a simple fiber-optic interferometer consisting of an electrical spectrum analyzer and a narrowband light source, which is commonly employed for observing the Brillouin gain spectrum. This…
We present a method to measure the spectral density of in-band optical transmission impairments without coherent electrical reception and digital signal processing at the receiver. We determine the method's accuracy by numerical simulations…
We demonstrate an optical fiber fault location method based on the frequency response of the modulated fiber optical backscattered signal in a steady state low-frequency step regime. Careful calibration and measurement allows for the…
This paper considers the application of FPGA-based IIR filtering to increase the usable bandwidth of a piezoelectric transducer used in optical phase locking. We experimentally perform system identification of the interferometer system with…
We demonstrate a high-accuracy distributed fiber-optic temperature sensor using superconducting nanowire single-photon detectors and single-photon counting techniques. Our demonstration uses inexpensive single-mode fiber at standard…
Power spectral density measurements of any sampled signal are typically restricted by both acquisition rate and frequency response limitations of instruments, which can be particularly prohibitive for video-based measurements. We have…