相关论文: Developing ZnO Nanoparticle embedded Antimicrobial…
ZnO films have been grown on gold (111) by electrodeposition using two different OH- sources, nitrate and peroxide, in order to obtain a comparative study between these films. The morphology, structural and optical characterization of the…
Three-dimensional hierarchical ZnO films with lotus-leaf-like micro/nano structures were successfully fabricated via a biomimetic route combining sol-gel technique, soft lithography and hydrothermal treatments. PDMS mold replicated from a…
High quality metal thin films and nanostructures are critical building blocks for next generation nanotechnologies. They comprise low-loss circuit elements in nanodevices, provide new catalytic pathways for water splitting and $CO_2$…
The exceptional conducting nature of graphene makes it a viable candidate for enhancing the effectiveness of photocatalytic and biomedical nanomaterials. Herein, the immobilization of monodispersed silicon dioxide (SiO2) nanoparticles on…
While most of the studies on molecular machines have been performed in solution, interfacing these supramolecular systems with solid-state nanostructures and materials is very important in view of their utilization in sensing components…
In the present work, we developed a sustainable and effective antimicrobial surface film based on Micro-Fibrillated Cellulose. The resulting porous cellulose thin film is barely noticeable to human eyes due to its sub-micron thickness, of…
Effect of ambient gases on photoluminescence (PL) and electrical conductivity of films prepared using ZnO nanoparticles (NPs) have been investigated. It is observed that NPs of size below 20 nm kept inside a chamber exhibit complete…
Nanocrystalline metals are promising radiation tolerant materials due to their large interfacial volume fraction, but irradiation-induced grain growth can eventually degrade any improvement in radiation tolerance. Therefore, methods to…
The COVID-19 pandemic has shown the urgent need for the development of efficient, durable, reusable and recyclable filtration media for the deep-submicron size range. Here we demonstrate a multifunctional filtration platform using porous…
This work reports the successful solid state synthesis of ZnO/NiFe2O4 nanocomposite by calcinations of both green synthesized ZnO nanorods and NiFe2O4 prismatic nanorods at high temperature (850 {\deg}C) for ten hours. These nanomaterials…
A novel sol-gel route to c-axis orientated undoped and Co, Fe, Mn and V doped ZnO films is reported. Sols were prepared from a hydrated zinc acetate precursor and dimethyl formamide (DMF) solvent. Films were spin-coated on to hydrophilic…
Zinc oxide thin films were deposited by ultrasonic spray pyrolysis technique using different Zinc precursors: Zinc acetate, Zinc nitrate and zinc chloride with different molarities. All deposited films were characterized by various…
The thin film configuration presents obvious practical advantages over the 1D implementation in energy harvesting systems such as easily manufacturing and processing and long lasting and stable devices. However, most of the ZnO-based…
Among the wide bandgap semiconductors, TiO$_{2}$ is the highly stable and cost-efficient semiconductor used for the different photocatalysis processes like water splitting, chemical waste degradation, anti-micro bacterial activities, and…
Nanocrystals of indium oxide (In$_2$O$_3$) with sizes below 10 nm were prepared in alumina matrixes by using a co-pulverization method. The used substrates such as borosilicate glasses or (100) silicon as well as the substrate temperatures…
ZnO nanostructured films were prepared by chemical bath deposition method on glass substrates without any assistance of either microwave or high pressure autoclaves. The effect of solute concentration on the pure wurtzite ZnO nanostructure…
We report the synthesis of colloidal Mn2+-doped ZnO (Mn2+:ZnO) quantum dots and the preparation of room-temperature ferromagnetic nanocrystalline thin films. Mn2+:ZnO nanocrystals were prepared by a hydrolysis and condensation reaction in…
Nanogenerators and self-powered nanosensors have shown the potential to power low-consumption electronics and human-machine interfaces, but their practical implementation requires reliable, environmentally friendly and scalable, processes…
Heterostructures of wurtzite based devices have attracted great research interests since the tremendous success of GaN in light emitting diodes (LED) industry. Among the possible heterostructure material candidates, high quality GaN thin…
Scaling of transistors has enabled continuous improvements in logic device performance, especially through materials engineering. However, surpassing horizontal limitations in chip manufacturing requires a vertical, third dimension.…