相关论文: Comparative Analysis of Conventional and Modified …
Hybrid microgrids integrating Grid-Following (GFL) and Grid-Forming (GFM) inverters present complex control challenges arising from the decoupling between long-term economic dispatch and real-time dynamic regulation, as well as the distinct…
In the last decades, the applications of power inverter increased rapidly. As a result, in spite of rectifier, an inverter with a high-power electronic oscillator has capability to convert direct current (DC) into alternating current (AC)…
The existing decentralized control for cascaded inverters is based on the assumption that all modules have same capacities, and a local fixed-amplitude-varied-phase voltage control is adopted for each inverter module. However, available…
This paper presents a design and implementation of a high-power Gallium Nitride (GaN)-based multilevel Hbridge inverter to excite wireless charging coils for the wireless power transfer of electric vehicles (EVs). Compared to the…
In this work, using 3D device simulation, we perform an extensive gate to source/drain underlap optimization for the recently proposed hybrid transistor, HFinFET, to show that the underlap lengths can be suitably tuned to improve the on-off…
Electrified powertrains rely heavily on magnetics for power conversion, where cost, volume, and weight concerns make integrated multi-use designs an attractive solution. With EV powertrain architectures requiring a boost stage being a major…
The ever-increasing use of renewable energy sources has underlined the role of power electronic converters as an interface between these resources and the power grid. One application of these converters is in three-phase inverters utilized…
In this paper we are interested in the problem of adaptive synchronization of a voltage source converter with a possibly weak grid with unknown angle and frequency, but knowledge of its parameters. To guarantee a suitable synchronization…
A family of interleaved current-fed high step-up dc-dc converters are introduced and analyzed here by combining a voltage multiplier (VM) and an active clamp circuit for high-voltage high-power applications. Low input currents and output…
This paper proposes a methodology for shortlisting protection system configurations for large HVDC switching stations, which are expected in multiterminal HVDC grids and electrical energy hubs (or energy islands). This novel approach…
Transformer terminal equivalents obtained via admittance measurements are suitable for simulating high-frequency transient interaction between the transformer and the network. This paper augments the terminal equivalent approach with a…
Hybrid precoding is a promising technique for mmWave massive MIMO systems, as it can considerably reduce the number of required radio-frequency (RF) chains without obvious performance loss. However, most of the existing hybrid precoding…
In this paper, a non-isolated high step-up DC-DC converter has been proposed for renewable energy applications. The proposed structure converter has been derived from the fundamental Zeta converter, in both of which only a single switch is…
The grid-forming converter is an important unit in the future power system with more inverter-interfaced generators. However, improving its performance is still a key challenge. This paper proposes a generalized architecture of the…
This paper investigates the utilization of transmission switching to improve synchronization performance of low-inertia grids. The synchronization performance of power girds is first measured by the $\mathcal{H}_2$ norm of linearized power…
Multi-active bridge (MAB) converters, the core of the state-of-the-art medium-voltage power electronic transformers, can flexibly connect multiple DC ports among distributed DC grids and loads, but suffer from hard switching under…
Small-signal models of DC-DC converters are often based on a state-space averaging approach, from which both control-oriented and other frequency-domain characteristics, such as input or output impedance, can be derived. Updating these…
Vanadium dioxide (VO2) exhibits a hysteretic insulator-to-metal transition near room temperature, forming the foundation for various forms of resistive switching devices. Usually, these are realized in the form of two-terminal bridge-like…
The increasing integration of power electronic devices is driving the development of more advanced tools and methods for the modeling, analysis, and control of modern power systems to cope with the different time-scale oscillations. In this…
This work studies a variant of hybrid beamforming, namely, hybrid beamforming with selection (HBwS), as an attractive solution to reduce the hardware cost of multi-user Massive Multiple-Input-Multiple-Output systems, while retaining good…