相关论文: Influence of non-uniformity in sapphire substrates…
Cooling down test masses to cryogenic temperatures is a way to reduce the thermal noise of gravitational wave detectors. Crystalline materials are considered the most promising materials for fabricating cryogenic test masses and their…
In real telescopes, the optical parameters evolve with time, and the degradation is often not uniform. This introduces variations in the image profile and therefore photo-centre displacements which, unless corrected, may result in…
A method is presented for modelling the optical properties of a photonic crystal structure mounted on a substrate which is thick enough that the light reflected from the back is incoherent with reflections from the front. Transmission and…
We report the reduction of the thermal lensing in cryogenic sapphire mirrors, which is planed to be used in the Large scale Cryogenic Gravitational wave Telescope (LCGT) project. We measured three key parameters of sapphire substrate for…
It is well known that gravitational waves distort equilibrium matter globally, making them amenable to detection with laser interferometers. Less well known is the fact that gravitational waves create local non-equilibrium stresses inside…
The primary scientific results of the future space-based gravitational wave interferometer LISA will come from the parameter inference of a large variety of gravitational wave sources. However, the presence of calibration errors could…
Crystalline materials are promising candidates as substrates or high-reflective coatings of mirrors to reduce thermal noises in future laser interferometric gravitational wave detectors. However, birefringence of such materials could…
This study presents a comprehensive optical analysis of titanium-doped sapphire (Ti:Sa) crystals, introducing two innovative measurement techniques to enhance the characterization of this material. The first method enables highly precise…
Currently, the Japanese gravitational wave laser interferometer KAGRA is under construction in the Kamioka mine. As one main feature, it will employ sapphire mirrors operated at a temperature of 20K to reduce the impact from thermal noise.…
We report the first high-precision interferometer using large sapphire mirrors, and we present the first direct, broadband measurements of the fundamental thermal noise in these mirrors. Our results agree well with the thermoelastic-damping…
KAGRA is a 3-km cryogenic interferometric gravitational wave telescope located at an underground site in Japan. In order to achieve its target sensitivity, the relative positions of the mirrors of the interferometer must be finely adjusted…
Double neutron stars are one of the most promizing sources for terrestrial gravitational wave interferometers. For actual interferometers and their planned upgrades, the probability of having a signal present in the data is small, but as…
The figure of merit (FoM) of Ti:Sapphire (Ti:Sa) crystals is a generally used means to evaluate the quality of the crystals. Despite the importance of Ti:Sa, the question of FoM measurement precision stayed out of focus, while the…
We study the decoherence of atomic interferometers due to the scattering of stochastic gravitational waves. We evaluate the `direct' gravitational effect registered by the phase of the matter waves as well as the `indirect' effect…
Using a custom-built scanning system, we generated maps of birefringence on reflection at $\lambda=1064$~nm from single-crystal GaAs/Al$_{0.92}$Ga$_{0.08}$As Bragg reflectors (henceforth ``AlGaAs coatings''). Ten coatings were bonded to…
The sensitivity of the gravitational-wave detector KAGRA, presently under construction, will be limited by quantum noise in a large fraction of its spectrum. The most promising technique to increase the detector sensitivity is the injection…
It is well known that direct observation of interference and diffraction pattern in the intensity distribution requires a spatially coherent source. Optical waves emitted from portions beyond the coherence area possess statistically…
High-quality test mass substrates play essential roles in laser interferometric gravitational wave detectors. Inhomogeneous birefringence distribution in test mass substrates, however, can degrade the sensitivity of the detector by…
Matter-wave interferometry with solids is highly susceptible to minute fluctuations of environmental fields, including gravitational effects from distant sources. Hence, experiments require a degree of shielding that is extraordinarily…
We consider the propagation of gravitational waves in the late time Universe with the presence of structure. Before detection, gravitational waves emitted from distant sources have to traverse through regions of spacetime which are far from…