相关论文: Mixer-First Receiver with wide-RF Range
A 25-40GHz passive mixer-first receiver using a novel architecture for digital beamforming arrays is proposed. The architecture uses a novel technique for impedance matching using the on-resistance of the mixers in the receiver and matching…
This article addresses the modeling and cancellation of self-interference in full-duplex direct-conversion radio transceivers, operating under practical imperfect radio frequency (RF) components. Firstly, detailed self-interference signal…
Over the past few years, significant growth has been observed in using MEMS based passive components in the RF microelectronics domain, especially in transceiver components. This is due to some excellent properties of the MEMS devices like…
A low cost solution for constructing receiver signal points is investigated that combines a large number of constrained radio frequency (RF) frontends with a limited number of full RF chains. The constrained RF front ends have low cost and…
Superconducting Quantum Interference Filters (SQIF) are promising devices for Radio- Frequency (RF) detection combining low noise, high sensitivity, large dynamic range and wide-band capabilities. Impressive progress have been made recently…
The concept of self-mixing antenna arrays is presented and analyzed with respect to its beneficial behavior of large gain over a wide angular range. The large gain is attained by an antenna array with large element spacing, where all array…
Consider a MIMO interference channel whereby each transmitter and receiver are equipped with multiple antennas. The basic problem is to design optimal linear transceivers (or beamformers) that can maximize system throughput. The recent work…
Classical beamforming techniques rely on highly linear transmitters and receivers to allow phase-coherent combining at the transmitter and receiver. The transmitter uses beamforming to steer signal power towards the receiver, and the…
This paper focuses on the joint synthesis of constant envelope transmit signal and receive filter aimed at optimizing radar performance in signal-dependent interference and spectrally contested-congested environments. To ensure the desired…
Massive multiple-input multiple-output (MIMO) is expected to play a central role in future wireless systems. The deployment of large antenna arrays at the base station and the mobile users offers multiplexing and beamforming gains that…
Integrated sensing and communication (ISAC) has been envisioned as a solution to realize the sensing capability required for emerging applications in wireless networks, while efficiently utilizing the available spectral, hardware and energy…
For future wireless communication systems, full duplex is seen as a possible solution to the ever present spectrum shortage. The key aspect to enable In-Band Full Duplex (IBFD) is sufficient cancellation of the unavoidable Self-Interference…
Wireless communication systems can be enhanced at the link level, in medium access, and at the network level when transceivers are equipped with full-duplex capability: the transformative ability to simultaneously transmit and receive over…
Matrix pair beamformer (MPB) is a promising blind beamformer which exploits the temporal signature of the signal of interest (SOI) to acquire its spatial statistical information. It does not need any knowledge of directional information or…
Full-duplex millimeter wave (mmWave) communication has shown increasing promise for self-interference cancellation via hybrid precoding and combining. This paper proposes a novel mmWave multiple-input multiple-output (MIMO) design for…
Precision instrumentation systems, such as optical receivers and other current-output measurement systems, often contain a transimpedance amplifier (TIA). The commonly used resistive feedback TIA (RF-TIA) has a drawback in its practical…
In an in-band full-duplex system, radios transmit and receive simultaneously in the same frequency band at the same time, providing a radical improvement in spectral efficiency over a half-duplex system. However, in order to design such a…
Radio Frequency Interference (RFI) greatly reduces sensitivity of radio observations to astrophysical signals and creates false positive candidates in searches for radio transients. Real signals are missed while considerable computational…
We propose practical transceiver structures for double-sided massive multiple-input-multiple-output (MIMO) systems. Unlike standard massive MIMO, both transmit and receive sides are equipped with high-dimensional antenna arrays. We leverage…
Tunable, low-loss, narrowband, and frequency-stabilized filters play a critical role in the realization of transceivers for efficient signal processing in telecommunications and sensing applications in the presence of strong interference…