相关论文: Digital Predistortion in Large-Array Digital Beamf…

In large-scale antenna systems, using one-bit analog-to-digital converters (ADCs) has recently become important since they offer significant reductions in both power and cost. However, in contrast to high-resolution ADCs, the coarse…

Digital micromirror devices have gained popularity in wavefront shaping, offering a high frame rate alternative to liquid crystal spatial light modulators. They are relatively inexpensive, offer high resolution, are easy to operate, and a…

In this paper, we investigate the robust linear precoder design for three dimensional (3D) massive multi-input multi-output (MIMO) downlink with uniform planar array (UPA) and imperfect channel state information (CSI). In practical massive…

In order to cope with the large path-loss exponent of mm-Wave channels, a high beamforming gain is needed. This can be achieved with small hardware complexity and high hardware power efficiency by Hybrid Digital-Analog (HDA) beamforming,…

Hybrid analog-digital precoding is challenging for broadband millimeter-wave (mmWave) massive MIMO systems, since the analog precoder is frequency-flat but the mmWave channels are frequency-selective. In this paper, we propose a principal…

To keep massive MIMO systems cost-efficient, power amplifiers with rather small output dynamic ranges are employed. They may distort the transmit signal and degrade the performance. This paper proposes a distortion aware precoding scheme…

In this paper, we propose two low-complexity optimization methods to reduce peak-to-average power ratio (PAPR) values of orthogonal frequency division multiplexing (OFDM) signals via alternating direction method of multipliers (ADMM).…

The passive electronically scanned array (PESA) is widely used due to its simple structure and low cost. {Its antenna weights have unit modulus and thus, only the weights phases can be controlled. PESA has limited degrees of freedom for…

Multiple-input multiple-output (MIMO) millimeter wave (mmWave) systems are vulnerable to hardware impairments due to operating at high frequencies and employing a large number of radio- frequency (RF) hardware components. In particular,…

Hybrid analog-digital beamforming stands out as a key enabler for future communication systems with a massive number of antennas. In this paper, we investigate the hybrid precoder design problem for angle-of-departure (AoD) estimation,…

In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by…

In this paper, a joint transmitter and receiver design for pattern division multiple access (PDMA) is proposed. At the transmitter, pattern mapping utilizes power allocation to improve the overall sum rate, and beam allocation to enhance…

Polarization reconfigurable (PR) antennas enhance spectrum and energy efficiency between next-generation node B(gNB) and user equipment (UE). This is achieved by tuning the polarization vectors for each antenna element based on channel…

Digital phased arrays have often been disregarded for millimeter-wave communications since the analog-to-digital converters (ADCs) are power-hungry. In this paper, we provide a different perspective on this matter by demonstrating…

Multiple-antenna systems is a key technique to serve multiple users in future wireless systems. For low energy consumption and hardware complexity we first consider transmit symbols with constant magnitude and then 1-bit digital-to-analog…

We propose an over-the-air digital predistortion optimization algorithm using reinforcement learning. Based on a symbol-based criterion, the algorithm minimizes the errors between downsampled messages at the receiver side. The algorithm…

A promising approach for multi-microphone speech separation involves two deep neural networks (DNN), where the predicted target speech from the first DNN is used to compute signal statistics for time-invariant minimum variance…

Future multi-input multi-output (MIMO) wireless communications systems will use beamforming as a first-step towards realizing the capacity requirements necessitated by the exponential increase in data demands. The focus of this work is on…

Broadband beamforming is a technique to obtain the signal with a wide range of frequencies. It maintains the signal integrity and spatial selectivity over frequencies. This is important in several applications such as microphone array,…

Dispersion pre-compensation is shown to potentially lead to a substantial non-linearity reduction in PM-QPSK links that use a mixture of high and low dispersion fibers. However, the much larger PAPR of the pre-compensated signal poses…