相关论文: Digital Predistortion in Large-Array Digital Beamf…

Dynamic metasurface antennas (DMA) provide low-power beamforming through reconfigurable radiative slots. Each slot has a tunable component that consumes low power compared to typical analog components like phase shifters. This makes DMAs a…

Millimeter wave (mmWave) systems will likely employ large antenna arrays at both the transmitters and receivers. A natural application of antenna arrays is simultaneous transmission to multiple users, which requires multi-user precoding at…

Nonlinear distortion in power amplifiers (PA) can significantly degrade performance of orthogonal frequency division multiplexed (OFDM) communication systems. This paper presents a joint maximum-likelihood channel frequency response and…

High Peak to Average Power Ratio (PAPR) of the transmitted signal is a serious problem in multicarrier modulation systems. In this paper a new technique for reduction in PAPR of the Multicarrier Code Division Multiple Access (MC CDMA)…

The Minimum Variance Distortionless Response (MVDR) beamforming technique is widely applied in array systems to mitigate interference. However, applying MVDR to large arrays is computationally challenging; its computational complexity…

In this paper, we develop a framework to investigate the performances of different hybrid beamforming architectures for massive multiple input multiple output (MIMO) systems impaired by power amplifier (PA) nonlinearities. Indirect learning…

Recently, full duplex (FD) has been studied in 5G LTE millimeter wave (mmWave) cellular communications for New Radio in 3GPP releases 15-17. FD allows bidirectional transmission over the same resources and has the potential to reduce…

Diversity techniques have been applied for decades to overcome the effects of fading, which is one of the most challenging problems in wireless communications due to the randomness of the wireless channel. However, existing diversity…

The potential of using of millimeter wave (mmWave) frequency for future wireless cellular communication systems has motivated the study of large-scale antenna arrays for achieving highly directional beamforming. However, the conventional…

The conventional digital beamforming technique needs one radio frequency (RF) chain per antenna element. High power consumption, significantly high cost of RF chain components per antenna and complex signal processing task at base band…

Non-linear transceivers and non-reciprocity of downlink and uplink channels are two major challenges in the deployment of massive multiple-input-multiple-output (MIMO) systems. We consider an over-the-air (OTA) approach for digital…

Modern radio systems and transceivers utilize carrier aggregation (CA) to meet the demands for higher and higher data rates. However, the adoption of CA in the existing Long Term Evolution (LTE)-Advanced and emerging 5G New Radio (NR)…

Beamforming is central to the processing function of all phased arrays and becomes particularly challenging with a large number of antenna element (e.g. >100,000). The ability to beamform efficiently with reasonable power requirements is…

Hybrid beamforming is key to achieving energy-efficient 5G wireless networks equipped with massive amount of antennas. Low-resolution data converters bring yet another degree of freedom to energy efficiency for the state-of-the-art 5G…

With global IMT traffic expected to grow 10-100 times from 2020 to 20301, the Terahertz (THz) spectrum offers a promising solution to satisfy such forecasts. However, occupying the THz spectrum comes with its own challenges, an important…

Millimeter wave communications require multibeam beamforming in order to utilize wireless channels that suffer from obstructions, path loss, and multi-path effects. Digital multibeam beamforming has maximum degrees of freedom compared to…

Communications in high-mobility environments have caught a lot of attentions recently. In this paper, fast time-varying channels for massive multiple-input multiple-output (MIMO) systems are addressed. We derive the exact channel power…

In cell-free massive MIMO systems with multiple distributed access points (APs) serving multiple users over the same time-frequency resources, downlink beamforming is done through spatial precoding. Precoding vectors can be optimally…

Beamforming is traditionally associated with coherent summation of signals from antenna elements of the same polarization, here referred to as single polarization beamforming (SPBF). In this paper we focus on a new method, called dual…

In this paper, we aim to design highly energy efficient end-to-end communication for millimeter wave multiple-input multiple-output systems. This is done by jointly optimizing the digital-to-analog converter (DAC)/analog-to-digital…