相关论文: MRPC3b mass production for CBM-TOF and eTOF at STA…
In order to improve the particle identification capability of the Beijing Spectrometer III (BESIII),t is proposed to upgrade the current endcap time-of-flight (ETOF) detector with multi-gap resistive plate chamber (MRPC) technology. Aiming…
In order to further enhance the particle identification capability of the Beijing Spectrometer (BESIII), it is proposed to upgrade the current end-cap time-of-flight (eTOF) detector with multi-gap resistive plate chamber (MRPC). The…
Large area triple GEM chambers will be employed in the first two stations of the MuCh system of the CBM experiment at the upcoming Facility for Antiproton and Ion Research FAIR in Darmstadt/Germany. The GEM detectors have been designed to…
The MicroBooNE detector utilizes a liquid argon time projection chamber (LArTPC) with an 85 t active mass to study neutrino interactions along the Booster Neutrino Beam (BNB) at Fermilab. With a deployment location near ground level, the…
The large Time-Of-Flight (TOF) array is one of the main detectors devoted to charged hadron identification in the mid-rapidity region of the ALICE experiment at the LHC. It allows separation among pions, kaons and protons up to a few GeV/c,…
The High-Acceptance DiElectron Spectrometer (HADES) at GSI Darmstadt consists of a 6-coil toroidal magnet centered on the beam axis and six identical detection sections located between the coils and covering polar angles between $18^\circ$…
In the paper, we discuss the development of the multi-gap resistive plate chamber Time-of-Flight (TOF) technology and the production of the STAR TOF detector in China at the beginning of the 21st century. Then we review recent experimental…
Luminosity spectrum and accelerator background levels strongly influence the experimental conditions and have an important impact on detector design. The expected rates of the main beam-beam products at CLIC 3 TeV CM energy, taking into…
The RHIC Beam Energy Scan focuses on the study of the QCD phase diagram --- temperature ($T$) vs. baryon chemical potential ($\mu_B$). The aim is to verify some predictions from QCD: that a cross-over occurs at $\mu_B$ = 0, that there…
In CBM Experiment at FAIR, dimuons will be detected by a Muon Chamber (MUCH) consisting of segmented absorbers of varying widths and tracking chambers sandwiched between the absorber-pairs. In this fixed target heavy-ion collision…
Particle identification (PID) capabilities are studied by using the Time Projection Chamber (TPC) and a Time-Of-Flight (TOF) detector together at STAR. The identification capability of charged hadrons is greatly extended compared with that…
Time of flight system (TOF) based on MRPC technology is widely used in modern physics experiments, and it also plays an important role in particle identification. With the increase of accelerator energy and luminosity, TOF system is…
The low cost and high resolution Multi-gap Resistive Plate Chamber (MRPC) opens up a new possibility to find an efficient alternative detector for the Time of Flight (TOF) based Positron Emission Tomography, where the sensitivity of the…
A 256-channel time-of-flight (TOF) electronics system has been developed for a beam line facility called "Back-n WNS" in China Spallation Neutron Source (CSNS). This paper shows the structure and performance of electronics system and the…
To achieve high precision and accuracy for mass measurements of exotic nuclei by Time-of-flight (TOF) methods: high-resolution beam-line magnetic-rigidity time-of-flight (B$\rho$-TOF) and in-ring isochronous mass spectrometry (IMS), a…
A new Beam Halo Monitor (BHM) detector system has been installed in the CMS cavern to measure the machine-induced background (MIB) from the LHC. This background originates from interactions of the LHC beam halo with the final set of…
First of its kind, the barrel section of the MIP Timing Detector is a large area timing detector based on LYSO:Ce crystals and SiPMs which are required to operate in an unprecedentedly harsh radiation environment (up to an integrated…
Azimuthal distributions of radial velocities of charged hadrons produced in nucleus-nucleus $(AB)$ collisions are compared with the corresponding azimuthal distribution of charged hadron multiplicity in the framework of a multiphase…
A foil-microchannel plate (MCP) detector, which uses electrostatic lenses and possesses both good position and timing resolutions, has been designed and simulated for beam diagnostics and mass measurements at the next-generation…
The Accelerator Mass Spectrometry technique makes it possible to measure rare long-lived isotopes such as $^{10}$Be, $^{14}$C, $^{26}$Al, $^{36}$Cl, $^{41}$Ca and $^{129}$I. The content of these isotopes can be at the level of 10$^{-15}$ of…