相关论文: When Is the Achievable Rate Region Convex in Two-U…

Massive multiple-input multiple-output (MIMO) systems are cellular networks where the base stations (BSs) are equipped with unconventionally many antennas, deployed on co-located or distributed arrays. Huge spatial degrees-of-freedom are…

Reconfigurable intelligent surfaces (RISs) have emerged as a prospective technology for next-generation wireless networks due to their potential in coverage and capacity enhancement. Previous works on achievable rate analysis of…

In this paper, we study the achievable rate region of 1-layer rate splitting (RS) in the presence of hardware impairment (HWI) and improper Gaussian signaling (IGS) for a single-cell reconfigurable intelligent surface (RIS) assisted…

We model the self-interference in a multiple input single output (MISO) full-duplex two-way channel and evaluate the achievable rate region. We formulate the boundary of the achievable rate region termed as the Pareto boundary by a family…

Recently, interest on the utilization of unmanned aerial vehicles (UAVs) has aroused. Specifically, UAVs can be used in cellular networks as aerial users for delivery, surveillance, rescue search, or as an aerial base station (aBS) for…

Reconfigurable intelligent surface (RIS) is an emerging technology to enhance wireless communication in terms of energy cost and system performance by equipping a considerable quantity of nearly passive reflecting elements. This study…

Massive multiple-input multiple-output (MIMO) is a promising technology aiming at achieving high spectral efficiency by deploying a large number of base station (BS) antennas using coherent combining. Channel aging due to user mobility is a…

In this work, in order to achieve higher spectrum efficiency, we propose a reconfigurable intelligent surface (RIS)-assisted multi-user communication uplink system. Different from previous work in which the RIS only optimizes the phase of…

Measurement results for millimeter wave LOS MIMO systems are presented with a focus on time variation and multipath propagation. Different system setups are used, including 2x2 and 3x3 MIMO, and involving different synchronization…

Multi-user Multiple-Input Multiple-Output (MIMO) offers big advantages over conventional point-to-point MIMO: it works with cheap single-antenna terminals, a rich scattering environment is not required, and resource allocation is simplified…

Innovative reconfigurable intelligent surface (RIS) technologies are rising and recognized as promising candidates to enhance 6G and beyond wireless communication systems. RISs acquire the ability to manipulate electromagnetic signals,…

Multiple-input multiple-output has been a key technology for wireless systems for decades. For typical MIMO communication systems, antenna array elements are usually separated by half of the carrier wavelength, thus termed as conventional…

Reconfigurable Intelligent Surfaces (RISs) are an emerging technology for future wireless communication systems, enabling improved coverage in an energy efficient manner. RISs are usually metasurfaces, constituting of two-dimensional…

The interference channel with degraded message sets (IC-DMS) refers to a communication model in which two senders attempt to communicate with their respective receivers simultaneously through a common medium, and one of the senders has…

This paper is concerned with massive-MIMO systems over Rician flat fading channels. In order to reduce the overhead to obtain full channel state information and to avoid the pilot contamination problem, by treating the scattered component…

MmWave multiple-input single-output (MISO) systems using a single-antenna receiver are regarded as promising solution for the near future, before the full-fledged 5G MIMO will be widespread. However, for MISO systems synchronization cannot…

Modern wireless communication systems are expected to provide improved latency and reliability. To meet these expectations, a short packet length is needed, which makes the first-order Shannon rate an inaccurate performance metric for such…

We consider a two--tile reconfigurable intelligent surface (RIS) assisted wireless network with a two-antenna transmitter and receiver over Rayleigh fading. We show that the average received signal-to-noise-ratio (SNR) optimal transmission…

This article analyzes the performance of sensing and communications (S\&C) achieved by a multiple-input multiple-output downlink integrated S\&C (ISAC) system. Three ISAC scenarios are analyzed, including the sensing-centric design,…

This paper examines the performance of a 2x2 Line of Sight (LoS) Multiple Input Multiple Output (MIMO) channel at three terahertz frequencies-340 GHz, 410 Ghz, and 460 GHz. While theoretical models predict very high channel capacities, we…