相关论文: Mist Flow Visualization for Round Jets in Aerosol …

Underexpanded jets are present in various engineering applications; in recent years, they have gained special attention because of the development of gas-fueled propulsion systems. In these apparatuses, the direct injection of fuels such as…

The Collison nebulizer (as well as its variations) has been widely used for generating fine aerosol droplets of a few microns from liquids of viscosity up to 1000 centipoise. It was originally developed for producing medical aerosols in…

The breakup of an interface into a cascade of droplets and their subsequent coalescence is a generic problem of central importance to a large number of industrial settings such as mixing, separations, and combustion. We study the breakup of…

The twin-nozzle jet in crossflow is a canonical flow structure in various engineering equipment, yet there are limited detailed studies focusing on its dynamical characteristics. In this study, the flow field of a twin-nozzle jet in…

This article delves into a numerical exploration of two-dimensional, incompressible, laminar flow within a confined diverging jet. The study aims to understand how variations in the inlet opening fraction and Reynolds number affect the heat…

We propose using a dielectric beveled nozzle for electrospray and electrohydrodynamic jet printing. This nozzle stabilizes the liquid ejection of low-conductivity liquids, considerably reducing the minimum flow rate below which the flow…

We explore the laminar to turbulence transition of round jets at low Reynolds number (Re < 1000) using a novel experimental setup and linear stability theory (LST). The setup has a large domain and a low disturbance environment which…

We propose a novel microfluidic "opposed-flow" geometry in which the continuous fluid phase is fed into a junction in a direction opposite the dispersed phase. This pulls out the dispersed phase into a micron-sized jet, which decays into…

We have produced a fluid dynamics video with data from Direct Numerical Simulation (DNS) of a jet in crossflow at several low values of the velocity inflow ratio R. We show that, as the velocity ratio R increases, the flow evolves from…

When a chordwise Reynolds number (Re) falls below about $10^5$ the performance of wings and aerodynamic sections become sensitive to viscous phenomena, including boundary layer separation and possible reattachment. Here, detailed…

We investigate the gas jet breakup and the resulting microbubble formation in a microfluidic flow-focusing device using ultra high-speed imaging at 1 million frames/s. In recent experiments [Dollet et al., Phys. Rev. Lett. 100, 034504…

Velocity profiles and wall shear stress values in the wall jet region of planar underexpanded impinging jets are parameterized based on nozzle parameters (stand-off height, jet hydraulic diameter, and nozzle pressure ratio). Computational…

We analyze the flow of a planar gas jet impinging on a thin film, dragged by a vertical moving wall. In the coating industry, this configuration is known as jet wiping, a process in which impinging jets control the thickness of liquid…

We perform fully relativistic hydrodynamic simulations of the deceleration and lateral expansion of a relativistic jet as it expands into an ambient medium. The hydrodynamic calculations use a 2D adaptive mesh refinement (AMR) code, which…

In this article, we construct a novel 1D-model of microfluidic laminar flows in tapered circular and rectangular channels assuming the flow in channels fully developed. In the model, we take into account the inertance and dynamic pressure…

Breakup of a liquid jet into a chain of droplets is common in nature and industry. Previous researchers developed profound mathematic and fluid dynamic models to address this breakup phenomenon starting from tiny perturbations. However, the…

The present study aims to investigate the role of injector geometry, particularly injector tube length to diameter ratio (L/D) in liquid jet stability and breakup in presence of crossflow. Water is injected into a crossflow of air.…

Traditionally, circular orifices have been used for generating aerosols, however in recent times non-circular orifices are being considered due to their superior atomization and mixing features. In this work, we experimentally investigate…

Relativistic jets are believed to have a substantial impact on the gas dynamics and evolution of the interstellar medium (ISM) of their host galaxies. In this paper, we aim to draw a link between the simulations and the observable…

The collision of a liquid drop against a small target results in the formation of a thin liquid sheet that extends radially until it reaches a maximum diameter. The subsequent retraction is due to the air-liquid surface tension. We have…