相关论文: Fabrication of highly dense isotropic Nd-Fe-B bond…

Hot Isostatic Pressing was applied to synthesize bulk samples with diameter up to 30 mm starting with Alfa Aesar magnesium diboride powder. HIPing at 2 kbar, 1000 C with cooling under pressure (DMCUP cycle) resulted in a fully dense (or low…

The incessant technological pursuit towards a more sustainable and green future depends strongly on permanent magnets. At present, their use is widespread, making it imperative to develop new processing methods that generate highly…

Nanosheets of nickel with thickness equal to 0.6 nm have been grown within the interlayer spaces of Na-4 mica. The sheets are made up of percolative clusters of nanodisks. Magnetization characteristics indicate a superparamagnetic behavior…

We aim at combining high coercivity magnetic nanowires in a polymer matrix in a view to fabricate rare--earth free bonded magnets. In particular, our aim is to fabricate anisotropic materials by aligning the wires in the polymer matrix. We…

Thin films of Nd$_{0.5}$Ca$_{0.5}$MnO$_{3}$ manganites with colossal magnetoresistance (CMR) properties have been synthesized by the Pulsed Laser Deposition technique on (100)-SrTiO$_{3}$. The lattice parameters of these manganites and…

Impact of rapid thermal processing (RTP) on microstructure and magnetic properties of Gd-Fe thin films have been investigated with a special emphasis to magnetic microstructure. 100 nm thick amorphous Gd-Fe film shows elongated stripe…

Mn1.5X0.5Sn (X = Cr, Mn, Fe, Co) nanomaterials in the hexagonal Ni2In-type crystal structure have been prepared using arc-melting and melt spinning. All the rapidly quenched Mn1.5X0.5Sn alloys show moderate saturation magnetizations with…

We present in this paper the structural and magnetic properties of high aspect ratio Co nanoparticles (~10) at high temperatures (up to 623 K) using in situ X ray diffraction (XRD) and SQUID characterizations. We show that the anisotropic…

The magnetic properties of carbon nanotube encapsulated nickel nanowires (C.E. nanowires of diameter ~ 10 nm), and its comparison to other forms of Ni are carried out in this work. The saturation magnetization (M_s) and coercivity (H_c) for…

Strained epitaxial growth provides the opportunity to understand the dependence of intrinsic and extrinsic properties of functional materials at frozen intermediate stages of a phase transformation. In this study, a combination of thin film…

This project is focused on investigating the structural performance of parts and structures produced using the latest additive manufacturing techniques. For additive manufacturing of test coupons, fused deposition modeling of…

The copper ferrite thin films have been deposited by RF sputtering at a 50W rf power. The As-deposited films are annealed in air at $800^{\circ}$C and then slow cooled. The As-deposited (AD) as well as slow cooled (SC) films are studied…

The anomalous Nernst effect in nanostructured magnetic materials is a key phenomenon to optimally control and employ the internal energy dissipated in electronic devices, being dependent on for instance the magnetic anisotropy of the active…

The static and dynamic magnetic properties of tetragonally distorted Mn--Ga based alloys were investigated. Static properties are determined in magnetic fields up to 6.5~T using SQUID magnetometry. For the pure Mn$_{1.6}$Ga film, the…

Severe plastic deformation using high-pressure torsion of ternary Cu-based materials (CuFeCo and CuFeNi) was used to fabricate bulk samples with a nanocrystalline microstructure. The goal was to produce materials featuring the granular…

Powder of magnesium diboride was hot isostatically pressed using three qualitatively different cycles: cooling under pressure (DMCUP), "standard" cycle with pressure and temperature reduced simultaneously and isothermal presure release.…

Within this work a passive and wireless magnetic sensor, to monitor linear displacements is proposed. We exploit recent advances in 3D printing and fabricate a polymer bonded magnet with a spatially linear magnetic field component…

We extend the solid-state nudged elastic band method to handle a non-conserved order parameter - in particular, magnetization, that couples to volume and leads to many observed effects in magnetic systems. We apply this formalism to the…

Gamma - Iron Oxide prepared by sol -gel process was used to produce nanocomposites with polyaniline of varying aniline concentrations. TEM shows the presence of chain like structure for lower polyaniline concentration. The room temperature…

Recent work [1] demonstrated high coercivity and magnetic moment in cobalt carbide nanoparticle assemblies and explained the high coercivity from first principles in terms of the high magnetocrystalline anisotropy of the cobalt carbide…