相关论文: Specific interface area in a thin layer system of …
For a well-stirred multiphase fluid systems the mean interface area per unit volume, $(\delta{S}/\delta{V})$, is a significant characteristic of the system state. In particular, it is important for the dynamics of systems of immiscible…
We present an approach to theoretical assessment of the mean specific interface area $(\delta{S}/\delta{V})$ for a well-stirred system of two immiscible liquids experiencing interfacial boiling. The assessment is based on the balance of…
The structure of a simple liquid may be characterised in terms of ground state clusters of small numbers of atoms of that same liquid. Here we use this sensitive structural probe to consider the effect of a liquid-vapour interface upon the…
In this paper we derive relations between the local resistivities inside the interfacial region and the overall resistances of the surface between two phases for a mixture. These resistivities are the coefficients in the force-flux…
A coarse grained description of a two phase fluid is used to study the steady state configuration of the interface separating the coexisting phases, and the motion of the contact line at which the interface intersects a solid boundary. The…
Numerical heat and mass transfer analysis of a configuration where a cool liquid hydrocarbon is suddenly introduced to a hotter gas at supercritical pressure shows that a well-defined phase equilibrium can be established before substantial…
The injection of liquid fuel at supercritical pressures is a relevant topic in combustion, but usually overlooked. In the past, the wrong assumption whereby the liquid experiments a fast transition to a supercritical state was made, thus…
We consider the problem of boiling of the direct contact of two immiscible liquids. An intense vapour formation at such a direct contact is possible below the bulk boiling points of both components, meaning an effective decrease of the…
The presence of even small amount of surfactant at the particle-laden fluid interface subjected to shear makes surface flow incompressible if the shear rate is small enough [T. M. Fischer et al, J. Fluid Mech. 558, 451 (2006)]. In the…
Interfacial flows close to a moving contact line are inherently multi-scale. The shape of the interface and the flow at meso- and macroscopic scales inherit an apparent interface slope and a regularization length, both called after Voinov,…
In this work we define a mean-field crossover generated by the Maxwell construction as the dividing interface for the vapor-liquid interface area. A highly accurate density-profile equation is thus derived, which is physically favorable and…
The dynamics of a thin layer of liquid, between a flat solid substrate and an infinitely-thick layer of saturated vapor, is examined. The liquid and vapor are two phases of the same fluid, governed by the diffuse-interface model. The…
We revisit the sharp-interface continuum thermodynamics of two-phase multicomponent fluid systems with interfacial mass. Since the published work is not fully consistent, we provide a rigorous derivation of the local balance equations and…
The mean ($\kappa$) and Gaussian ($\bar{\kappa}$) bending rigidities of liquid-liquid interfaces, of importance for shape fluctuations and topology of interfaces, respectively, are not yet established: even their signs are debated. Using…
The dynamics of compressible liquid-vapor flow depends sensitively on the microscale behavior at the phase boundary. We consider a sharp-interface approach, and propose a multiscale model to describe liquid-vapor flow accurately, without…
The interface between the vapor and liquid phase of quadrupolar-dipolar fluids is the seat of an electric interfacial potential whose influence on ion solvation and distribution is not yet fully understood. To obtain further microscopic…
A fluid in contact with a flat structureless wall constitutes the simplest interface system, but the fluid-wall interfacial tension cannot be trivially and even unequivocally determined due to the ambiguity in identifying the precise…
The effect of thermal fluctuations near a contact line of a liquid interface partially wetting an impenetrable substrate is studied analytically and numerically. Promoting both the interface profile and the contact line position to random…
Boundary conditions for the solid-liquid interface of the solidifying pure melt have been derived. In the derivation the model of Gibbs interface is used. The boundary conditions include both the state quantities of bulk phases are taken at…
Many physical situations are characterized by interfaces with a non trivial shape so that relevant geometric features, such as interfacial area, curvature or unit normal vector, can be used as main indicators of the topology of the…