相关论文: WINDOW: Wideband Demodulator for Optical Waveforms

Integrated Sensing and Communication (ISAC) with Orthogonal Frequency Division Multiplexing (OFDM) waveforms is a key enabler for next-generation wireless systems. Recent studies show that Convolutional Neural Networks (CNNs) can estimate…

The ability to cancel an OFDM signal is important to many wireless communication systems including Power-Domain Non-orthogonal Multiple Access (PD-NOMA), Rate-Splitting Multiple Access (RSMA), and spectrum underlay for dynamic spectrum…

Two important attributes of analog to digital converters (ADCs) are its sampling rate and dynamic range. The sampling rate should be greater than or equal to the Nyquist rate for bandlimited signals with bounded energy. It is also desired…

This paper investigates the design of analog beamforming at the receiver in millimeter-wave (mmWave) multiple-input multiple-output (MIMO) systems, aided by full digital chains featuring 1-bit ADCs. We advocate utilizing these full digital…

The future large adaptive telescopes will trigger new constraints for the calibration of Adaptive Optics (AO) systems equipped with pre-focal Deformable Mirrors (DM). The image of the DM actuators grid as seen by the Wave-Front Sensor (WFS)…

With their ability to handle an increased amount of information, multivariate and multichannel signals can be used to solve problems normally not solvable with signals obtained from a single source. One such problem is the decomposition…

Visible light communications (VLC) have recently attracted a growing interest and can be a potential solution to realize indoor wireless communication with high bandwidth capacity for RF-restricted environments such as airplanes and…

Massive multiple input and multiple output (MIMO) systems with orthogonal frequency division multiplexing (OFDM) are foundational for downlink multi-user (MU) communication in future wireless networks, for their ability to enhance spectral…

In this paper, we propose and evaluate two novel double-sequence low-resolution frequency synchronization methods in millimeter-wave (mmWave) systems. In our system model, the base station uses analog beams to send the synchronization…

We consider the decoding of bit interleaved coded modulation (BICM) applied to both multiband and MIMO OFDM systems for typical scenarios where only a noisy (possibly very bad) estimate of the channel is provided by sending a limited number…

In this article, we investigate channel estimation for wideband millimeter-wave (mmWave) massive multiple-input multiple-output (MIMO) under hybrid architecture with lowprecision analog-to-digital converters (ADCs). To design channel…

Many communication systems involve high bandwidth, while sparse, radio frequency (RF) signals. Working with high frequency signals requires appropriate system-level components such as high-speed analog-to-digital converters (ADC). In…

To address the challenges of wireless video transmission over multipath fading channels, we propose a robust deep joint source-channel coding (DeepJSCC) framework by effectively exploiting temporal redundancy and incorporating robust…

Large-scale multiple-antenna systems with large bandwidth are fundamental for future wireless communications, where the base station employs a large antenna array. In this scenario, one problem faced is the large energy consumption as the…

In this paper, we propose a sub-Nyquist sampling (SNS) orthogonal frequency-division multiplexing (OFDM) radar system capable of reducing the analog-to-digital converter (ADC) sampling rate in OFDM radar without any additional manipulations…

Sampling theories lie at the heart of signal processing devices and communication systems. To accommodate high operating rates while retaining low computational cost, efficient analog-to digital (ADC) converters must be developed. Many of…

Recovering signals within limited dynamic range (DR) constraints remains a central challenge for analog-to-digital converters (ADCs). To prevent data loss, an ADCs DR typically must exceed that of the input signal. Modulo sampling has…

One way to reduce the power consumption in large-scale multiple-input multiple-output (MIMO) systems is to employ low-resolution analog-to-digital converters (ADCs). In this paper, we investigate antenna selection for large-scale MIMO…

Multi-user Orthogonal Frequency Division Multiplexing (OFDM) and Multiple Output Multiple Output (MIMO) have been widely adopted to enhance the system throughput and combat the detrimental effects of wireless channels. Recently,…

Broadband channel is often characterized by a sparse multipath channel where dominant multipath taps are widely separated in time, thereby resulting in a large delay spread. Traditionally, accurate channel estimation is done by sampling…