相关论文: Dispersive readout of a silicon quantum dot with a…
We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate-sensing technique against the well established quantum point…
The implementation of a quantum computer requires a qubit-specific measurement capability to read-out the final state of a quantum system. The model of spin dependent tunneling followed by charge readout has been highly successful in…
Quantum computers require interfaces with classical electronics for efficient qubit control, measurement and fast data processing. Fabricating the qubit and the classical control layer using the same technology is appealing because it will…
Developing fast, accurate and scalable techniques for quantum state readout is an active area in semiconductor-based quantum computing. Here, we present results on dispersive sensing of silicon corner state quantum dots coupled to…
We demonstrate dispersive readout of individual charge states in a gate-defined few-electron quantum dot in bilayer graphene. We employ a radio frequency reflectometry circuit, where an LC resonator with a resonance frequency close to 280…
Dispersive sensing is a powerful technique that enables scalable and high-fidelity readout of solid-state quantum bits. In particular, gate-based dispersive sensing has been proposed as the readout mechanism for future topological qubits,…
We demonstrate dispersive charge sensing of Si/SiGe single and double quantum dots (DQD) by coupling sub-micron floating gates to a radio frequency reflectometry (rf-reflectometry) circuit using the tip of an atomic force microscope (AFM).…
RF reflectometry offers a fast and sensitive method for charge sensing and spin readout in gated quantum dots. We focus in this work on the implementation of RF readout in accumulation-mode gate-defined quantum dots, where the large…
Silicon spin qubits have emerged as a promising path to large-scale quantum processors. In this prospect, the development of scalable qubit readout schemes involving a minimal device overhead is a compelling step. Here we report the…
We analyze the dispersive readout of superconducting charge and flux qubits as a quantum measurement process. The measurement oscillator frequency is considered much lower than the qubit frequency. This regime is interesting because large…
Spin qubits in silicon quantum dots offer a promising platform for a quantum computer as they have a long coherence time and scalability. The charge sensing technique plays an essential role in reading out the spin qubit as well as tuning…
The technique of dispersive gate sensing (DGS) uses a single electrode to readout a qubit by detecting the change in quantum capacitance due to single electron tunnelling. Here, we extend DGS from the detection of discrete tunnel events to…
In gate-based dispersive sensing, the response of a resonator attached to a quantum dot gate is detected by a reflected radio-frequency signal. This enables fast readout of spin qubits and tune up of arrays of quantum dots, but comes at the…
A crucial requirement for quantum computing, in particular for scalable quantum computing and error correction, is a fast and high-fidelity qubit readout. For semiconductor based qubits, one limiting factor for local low-power signal…
Quantum dot arrays are a versatile platform for the implementation of spin qubits, as high-bandwidth sensor dots can be integrated with single-, double- and triple-dot qubits yielding fast and high-fidelity qubit readout. However, for…
Electron spins in silicon quantum dots provide a promising route towards realising the large number of coupled qubits required for a useful quantum processor. At present, the requisite single-shot spin qubit measurements are performed using…
We report the use of dispersive gate sensing (DGS) as a means of probing the charge environment of heterostructure-based qubit devices. The DGS technique, which detects small shifts in the quantum capacitance associated with single-electron…
We demonstrate a low loss, chip-level frequency multiplexing scheme for readout of scaled-up spin qubit devices. By integrating separate bias tees and resonator circuits on-chip for each readout channel, we realize dispersive gate-sensing…
Radio-frequency dispersive read-out can provide a useful probe to nano-scale structures such as nano-wire devices, especially when the implementation of charge sensing is not straightforward. Here we demonstrate dispersive `gate-only'…
The performance of a wide range of quantum computing algorithms and protocols depends critically on the fidelity and speed of the employed qubit readout. Examples include gate sequences benefiting from mid-circuit, real-time,…