相关论文: Temperature effects in deep-water hydrate foam
Controlling the temperature distribution inside catalytic fixed bed reactors is crucial for yield optimization and process stability. Yet, in situ temperature measurements with spatial and temporal resolution are still challenging. In this…
In this study, analysis of shell and tube heat exchanger (HE) is performed. Theory part on heat transfer, calculation of heat exchanger and general thermal and hydrological properties are described. Several models are developed and computed…
Molecular dynamic simulations were performed for ice Ih with a free surface by using four water models, SPC/E, TIP4P, TIP4P/Ice and TIP4P/2005. The behavior of the basal plane, the primary prismatic plane and of the secondary prismatic…
Manipulating surface topography is one of the most promising strategies for increasing the efficiency of numerous industrial processes involving droplet contact with superheated surfaces. In such scenarios, the droplets may immediately boil…
In the conventional picture, the temperature of a liquid bath in the quiescent state is uniform down to thermal fluctuation length scales. Here we examine the impact of a low frequency shear mechanical field (Hz) on the thermal equilibrium…
This article describes experiments performed with an ultracold gas of metastable helium above the Bose-Einstein transition. The gas is trapped in an harmonic magnetic potential and collective excitations are induced. Both the frequency and…
Nafion is a perfluorosulfonated polymer, widely used in Proton Exchange Membrane Fuel Cells. This polymer adopts a complex structural organisation resulting from the microsegregation between hydrophobic backbones and hydrophilic sulfonic…
A first-principles density functional method along with the direct solution of linearized Boltzmann transport equations are employed to systematically analyze the low-temperature thermal transport in crystalline GeTe. The extensive thermal…
The effect of mid-T heat treatment on flux trapping sensitivity was measured on several 1.3 GHz single cell cavities subjected to vacuum annealing at temperature of 150 - 400 $^\circ$C for a duration of 3 hours. The cavity was cooldown with…
We report the combined results of molecular dynamics simulations and theoretical calculations concerning various dynamical arrest transitions in a model system representing a dipolar fluid, namely, N (softcore) rigid spheres interacting…
We perform molecular dynamics simulations of 512 water-like molecules that interact via the TIP5P potential and are confined between two smooth hydrophobic plates that are separated by 1.10 nm. We find that the anomalous thermodynamic…
The temperature of the low-density intergalactic medium is set by the balance between adiabatic cooling resulting from the expansion of the universe, and photo-heating by the UV-background. A sudden injection of entropy from the…
Methanol is formed via surface reactions on icy dust grains. Methanol is also detected in the gas-phase at temperatures below its thermal desorption temperature and at levels higher than can be explained by pure gas-phase chemistry. The…
A full 3-dimensional compressible magnetohydrodynamic (MHD) simulation is conducted to investigate the thermal responses of a coronal loop to the dynamic dissipation processes of MHD waves. When the foot points of the loop are randomly and…
A recent survey of the fine-structure excitation of neutral carbon reveals that the interstellar medium in the Galactic plane exhibits a thermal pressure, nT/k, that ranges from about 10^3 to 10^4 cm{-3}K from one location to the next, with…
Ionic liquids have been suggested as new engineering fluids, namely in the area of heat transfer, as alternatives to current biphenyl and diphenyl oxide, alkylated aromatics and dimethyl polysiloxane oils, which degrade above 200 {\deg}C…
We have performed high resolution 3D simulations with adaptive mesh refinement, following the ISM evolution in a star forming galaxy both on small (<1 pc) and large (>10 kpc) scales, enabling us to track structures in cooling shock…
Liquid water exhibits anomalous behavior in the supercooled region. A popular hypothesis to explain supercooled water's anomalies is the existence of a metastable liquid-liquid transition terminating at a critical point. The hypothesized…
In this work, the effect of the range of the dispersive interactions in the determination of the three-phase coexistence line of the CO$_2$ and CH$_4$ hydrates has been studied. In particular, the temperature ($T_3$) at which solid hydrate,…
The behavior at the air/water interface of multilamellar tubes made of the ethanolamine salt of the 12-hydroxy stearic acid as a function of the temperature has been investigated using Neutron Reflectivity. Those tubes are known to exhibit…