相关论文: Gram Schmidt Based Greedy Hybrid Precoding for Fre…

This work jointly addresses user scheduling and precoder/combiner design in the downlink of a wideband millimeter wave (mmWave) communications system. We consider Orthogonal Frequency Division Multiplexing (OFDM) modulation to overcome…

We propose a greedy minimum mean squared error (MMSE)-based antenna selection algorithm for amplify-and-forward (AF) multiple-input multiple-output (MIMO) relay systems. Assuming equal-power allocation across the multi-stream data, we…

Efficient resource allocation with hybrid precoder design is essential for massive MIMO systems operating in millimeter wave (mmW) domain. Owing to a higher energy efficiency and a lower complexity of a partially connected hybrid…

In general, the zero-forcing (ZF) precoding suffers from a severe receive signal-to-noise ratio (SNR) degradation in the high interference regime. However, recent evidences from realistic measurements demonstrated that millimeter wave…

The high path loss associated with millimeter wave (mmWave) frequency communication can be compensated by large scale antenna arrays such as multiple-input multiple-output (MIMO) systems. The hybrid beamforming architecture which uses fewer…

Numerous linear and non-linear data-detection and precoding algorithms for wideband massive multi-user (MU) multiple-input multiple-output (MIMO) wireless systems that rely on orthogonal frequency-division multiplexing (OFDM) or…

Hybrid analog and digital beamforming has emerged as a key enabling technology for millimeter wave (mmWave) massive multiple-input multiple-output (MIMO) communication systems since it can balance the trade-off between system performance…

In this paper, adaptive hybrid beamforming methods are proposed for millimeter-wave range massive multiple-input-multiple-output (MIMO) systems considering single carrier wideband transmission in uplink data mode. A statistical analog…

MIMO systems are considered as most promising for wireless communications. However, with an increasing number of radio front ends the corresponding energy consumption and costs become an issue, which can be relieved by the utilization of…

The timely precoding of frequency division duplex (FDD) massive multiple-input multiple-output (MIMO) systems is a substantial challenge in practice, especially in mobile environments. In order to improve the precoding performance and…

The wide bandwidths offered at millimeter-wave (mmWave) frequencies have made them an attractive choice for future wireless communication systems. Recent works have presented beamforming strategies for enabling in-band full-duplex (FD)…

Hybrid precoding design is challenging for millimeter-wave (mmWave) massive MIMO. Most prior hybrid precoding schemes are designed to maximize the sum spectral efficiency (SSE), while seldom investigate the bit-error-rate (BER). Therefore,…

Low-complexity beamformer design with practical constraints is an attractive research area for hybrid analog/digital systems in mm-wave massive multiple-input multiple-output (MIMO). This paper investigates interference-aware pre-beamformer…

Hybrid analog-digital (A/D) transceivers designed for millimeter wave (mmWave) systems have received substantial research attention, as a benefit of their lower cost and modest energy consumption compared to their fully-digital…

To realize mmWave massive MIMO systems in practice, Beamspace MIMO with beam selection provides an attractive solution at a considerably reduced number of radio frequency (RF) chains. We propose low-complexity beam selection algorithms…

Multiple input multiple output (MIMO) precoding is an efficient scheme that may significantly enhance the communication link. However, this enhancement comes with a cost. Many precoding schemes require channel knowledge at the transmitter…

This letter investigates the hybrid analog and digital beamforming (HBF) design for multiuser millimeter wave (mmWave) communication systems based on the minimum mean square error (MMSE) criterion. Using the alternating minimization method,…

Hybrid analog-digital beamforming stands out as a key enabler for future communication systems with a massive number of antennas. In this paper, we investigate the hybrid precoder design problem for angle-of-departure (AoD) estimation,…

This paper investigates the hybrid precoding design in millimeter-wave (mmWave) systems with a fully-adaptive-connected precoding structure, where a switch-controlled connection is deployed between every antenna and every radio frequency…

In millimeter wave (mmWave) communication systems, beamforming with large antenna arrays is critical to overcome high path losses. Separating all-digital beamforming into analog and digital stages can provide the large reduction in power…