相关论文: The Approximate Capacity of the MIMO Relay Channel

The multicast capacity of the Gaussian two-hop relay network with one source, $N$ relays, and $L$ destinations is studied. It is shown that a careful modification of the partial decode--forward coding scheme, whereby the relays cooperate…

This paper considers the multi-input multi-output (MIMO) relay channel where multiple antennas are employed by each terminal. Compared to single-input single-output (SISO) relay channels, MIMO relay channels introduce additional degrees of…

Consider a Gaussian relay network where a source node communicates to a destination node with the help of several layers of relays. Recent work has shown that compress-and-forward based strategies can achieve the capacity of this network…

In this paper, we show that the capacity of the three-node Gaussian relay channel can be achieved to within 1 and 2 bit/sec/Hz using compress-and-forward and amplify-and-forward relaying, respectively.

In this paper, a Gaussian two-way relay channel, where two source nodes exchange messages with each other through a relay, is considered. We assume that all nodes operate in full-duplex mode and there is no direct channel between the source…

We study the capacity of the full-duplex bidirectional (or two-way) relay channel with two nodes and one relay. The channels in the forward direction are assumed to be different (in general) than the channels in the backward direction, i.e.…

The capacity of a class of multi-way relay channels, where L users communicate via a relay (at possibly different rates), is derived for the case where the channel outputs are modular sums of the channel inputs and the receiver noise. The…

This paper studies the transceiver design of the Gaussian two-pair two-way relay channel (TWRC), where two pairs of users exchange information through a common relay in a pairwise manner. Our main contribution is to show that the capacity…

Consider a Gaussian relay network where a number of sources communicate to a destination with the help of several layers of relays. Recent work has shown that a compress-and-forward based strategy at the relays can achieve the capacity of…

Standard upper and lower bounds on the capacity of relay channels are cut-set (CS), decode-forward (DF), and quantize-forward (QF) rates. For real additive white Gaussian noise (AWGN) multicast relay channels with one source node and one…

The capacity of a class of deterministic relay channels with the transmitter input X, the receiver output Y, the relay output Y_1 = f(X, Y), and a separate communication link from the relay to the receiver with capacity R_0, is shown to be…

We consider systems in which the transmitter conveys messages to the receiver through a capacity-limited relay station. The channel between the transmitter and the relay-station is assumed to be a frequency selective additive Gaussian noise…

The capacity of a class of Interference Relay Channels (IRC) -the Injective Semideterministic IRC where the relay can only observe one of the sources- is investigated. We first derive a novel outer bound and two inner bounds which are based…

Recently, it has been shown that a quantize-map-and-forward scheme approximately achieves (within a constant number of bits) the Gaussian relay network capacity for arbitrary topologies. This was established using Gaussian codebooks for…

A multi-input multi-output (MIMO) Gaussian channel with two transmit antennas and two receive antennas is studied that is subject to an input peak-power constraint. The capacity and the capacity-achieving input distribution are unknown in…

We consider the broadcast phase of a three-node network, where a relay node establishes a bidirectional communication between two nodes using a spectrally efficient two-phase decode-and-forward protocol. In the first phase the two nodes…

Consider the broadcast relay channel (BRC) which consists of a source sending information over a two user broadcast channel in presence of two relay nodes that help the transmission to the destinations. Clearly, this network with five nodes…

The use of 1-bit analog-to-digital converters (ADCs) is seen as a promising approach to significantly reduce the power consumption and hardware cost of multiple-input multiple-output (MIMO) receivers. However, the nonlinear distortion due…

We develop a new upper bound on the capacity of the relay channel that is tighter than previously known upper bounds. This upper bound is proved using traditional weak converse techniques involving mutual information inequalities and…

Transmit signal and bandwidth optimization is considered in multiple-antenna relay channels. Assuming all terminals have channel state information, the cut-set capacity upper bound and decode-and-forward rate under full-duplex relaying are…