相关论文: Maintenance Duration Estimate for a DEMO Fusion Po…
EDFA, as part of the Power Plant Physics and Technology programme, has been working on the pre-conceptual design of a Demonstration Power Plant (DEMO). As part of this programme, a review of the remote maintenance strategy considered…
Scheduled maintenance is likely to be lengthy and therefore consequential for the economics of fusion power plants. The maintenance strategy that maximizes the economic value of a plant depends on internal factors such as the cost and…
The findings of the EU 'Materials Assessment Group' (MAG), within the 2012 EU Fusion Roadmap exercise, are discussed. MAG analysed the technological readiness of structural, plasma facing and high heat flux materials for a DEMO concept to…
This paper develops maintenance policies for a system under condition monitoring. We assume that a number of defects may develop and the degradation process of each defect follows a gamma process, respectively. The system is inspected…
Now that ITER is under construction, interest is increasing in the specification and design of the successor machine, a Demonstration Power Plant (DEMO), which in Europe is coordinated by the EFDA Power Plant Physics and Technology…
Fusion energy is often regarded as a long-term solution to the world's energy needs. However, even after solving the critical research challenges, engineering and materials science will still impose significant constraints on the…
In Europe the work on the specification and design of a Demonstration Power Plant (DEMO) is being carried out by EFDA in the Power Plant Physics and Technology (PPP&T) programme. DEMO will take fusion from experimental research into showing…
Fusion energy is at an important inflection point in its development: multiple government agencies and private companies are now planning fusion pilot plants to deliver electricity to the grid in the next decade. However, realizing fusion…
In a fusion reactor materials will be subjected to significant fluxes of high-energy neutrons. As well as causing radiation damage, the neutrons also initiate nuclear reactions leading to changes in the chemical composition of materials…
Predictive maintenance (PdM) is a concept, which is implemented to effectively manage maintenance plans of the assets by predicting their failures with data driven techniques. In these scenarios, data is collected over a certain period of…
Fast rotation can improve the stability and confinement of fusion plasmas. However, to maintain a rapidly rotating fusion plasma in steady state, significant energy must be invested in spinning up each incoming fuel ion. We show here that,…
The need for maintenance is based on the wear of components of machinery. If this need can be defined reliably beforehand so that no unpredicted failures take place then the maintenance actions can be carried out economically with mini-mum…
Stellarator plasmas are externally controlled to a degree unparalleled by any other fusion concept, magnetic or inertial. This control is largely through the magnetic fields produced by external coils. The development of fusion energy could…
Predictions of material activation inventories will be a key input to virtually all aspects of the operation, safety and environmental assessment of future fusion nuclear plants. Additionally, the neutron-induced transmutation (change) of…
Predicting unscheduled breakdowns of plasma etching equipment can reduce maintenance costs and production losses in the semiconductor industry. However, plasma etching is a complex procedure and it is hard to capture all relevant equipment…
During the life of a wind farm, various types of costs arise. A large share of the operational cost for a wind farm is due to maintenance of the wind turbine equipment; these costs are especially pronounced for offshore wind farms and…
A study on future large accelerators [1] has considered a facility, which is designed, built and operated by a worldwide collaboration of equal partner institutions, and which is remote from most of these institutions. The full range of…
A possible design rule for preventing surface damage from thermal transients to solid tungsten armour is proposed and formulated for the plasma facing components (divertor, first wall) of magnetic fusion machines. The rule is based on…
Many governments are considering constructing new nuclear power plants to support the decarbonization of the energy system. On the one hand, dispatchable nuclear plants can complement fluctuating generation from wind and PV. On the other…
The plant efficiency of a nuclear fusion power plant is considered. During nominal operation, the plant efficiency is determined by the thermodynamic efficiency and the recirculated power fraction. However, on average the reactor operates…