相关论文: Theoretical and experimental study of a new single…

In this paper the concept and the first successful tests towards constructing a superconductive micro-undulator with a period length of 3.8 mm are described. The structures were built with a commercially available NbTi wire. A full 100…

A prototype of a novel superconductive undulator with a period length of 3.8 mm is described. The undulator is 100 periods long. In the first tests described in this paper the undulator was cooled in a helium bath and it was shown that it…

During the last years several attempts were undertaken to decrease the period length of undulators to the mm range. In this paper, a novel type of an in-vacuum undulator is described which is built with superconductive wires. The period…

During the last few years superconductive undulators with a period length of 3.8 mm and 14 mm have been built. In this paper scaling laws for these novel insertion devices are presented: a simple analytic formula is derived which describes…

Following the successful completion and testing of the sCCU-type undulator with 28mm period, we have designed, prototyped, constructed and bench tested another sCCU-type undulator with a much shorter 19mm-period magnetic structure.…

Thrust measurements were performed on a coil made of YBa2Cu3O7-d coated conductor acting as the excitation system of a single-sided linear synchronous motor. The superconducting coil was a single pancake in the shape of a racetrack with 100…

The improvement of accelerator parameters requires the transition to superconducting undulator technologies since SCUs allow higher magnetic fields compared to classical planar undulators with the same gap. The primary method for…

We report the implementation of two types of helical microundulators with a 6 mm period, built from axially magnetized helices fabricated from a single piece of rare-earth magnet. The first device, composed of two oppositely magnetized…

In this paper we discuss the main principles of magnetic design for superconducting magnets (dipoles and quadrupoles) for particle accelerators. We give approximated equations that govern the relation between the field/gradient, the current…

Following successful proof-of-concept experiments, we constructed compact varying-gap undulator with Hydraulic-Assist Driver. The 1.5m long undulator features a pure permanent magnet structure, period of 28.4 mm and a minimum gap of 6.75mm.…

A single-field-period quasi-isodynamic stellarator configuration is presented. This configuration, which resembles a twisted strip, is obtained by the method of direct construction, that is, it is found via an expansion in the distance from…

A conduction-cooled superconducting magnet producing a transverse field of 4 Tesla has been designed for the new generation multi-field coupling measurement system, which was used to study the mechanical behavior of superconducting samples…

This paper is about the mechanical design of superconducting accelerator magnets. First, we give a brief review of the basic concepts and terms. In the following sections, we describe the particularities of the mechanical design of…

We present a micron-sized induction magnetometer designed to measure the magnetic response of superconducting mesoscopic samples. The device is manufactured using the Memscap PolyMUMPs process and consists of two octagonal planar parallel…

Superconductors have been being applied to a variety of large-scale power applications, including magnets, electric machines, and fault current limiters, because they can enable a compact, lightweight and high efficiency design. In…

There is an interest to design superconducting magnet systems working in a persistent current mode. These systems continuously generate magnetic field with disconnected power source working like permanent magnet devices. In this paper…

A racetrack coil using MgB2/Cu strand has been fabricated and tested for transport current density at 4.2 K in self field. The monofilamentary strand was 1.0 mm OD and insulated with S-glass braid. Eighty turns of strand (42 m) were wound…

We report complex ac magnetic susceptibility measurements of a superconducting transition in very high-quality single-crystal alpha-uranium using microfabricated coplanar magnetometers. We identify an onset of superconductivity at T~0.7 K…

This paper summarizes our work on the fabrication, characterization, and modeling of a high-temperature superconducting double racetrack (DRC) coil. Using an in-house developed winding system, a DRC was wound with ReBCO superconducting…

It is shown that for superconductors with circumference $2\pi R$ approaching BCS coherence length $\xi_0$ minimal period of the response of all thermodynamic quantities to external magnetic field is set by $hc/e$ i.e. twice the…