相关论文: Environmental Influences on the LIGO Gravitational…
The sensitivity of the Advanced LIGO detectors to gravitational waves can be affected by environmental disturbances external to the detectors themselves. Since the transition from the former initial LIGO phase, many improvements have been…
The extreme sensitivity required for direct observation of gravitational waves by the Advanced LIGO detectors means that environmental noise is increasingly likely to contaminate Advanced LIGO gravitational wave signals if left unaddressed.…
In 2009-2010, the Laser Interferometer Gravitational-wave Observa- tory (LIGO) operated together with international partners Virgo and GEO600 as a network to search for gravitational waves of astrophysical origin. The sensitiv- ity of these…
Sources of geophysical noise, such as wind, sea waves and earthquakes, can have an impact on gravitational wave interferometers causing sensitivity worsening and gaps in data taking. During the 1-year long O3 run (April 1st 2019 to March…
Sources of geophysical noise (such as wind, sea waves and earthquakes) or of anthropogenic noise (nearby activities, road traffic, etc.) impact ground-based gravitational-wave (GW) interferometric detectors, causing transient sensitivity…
A first detection of terrestrial gravity noise in gravitational-wave detectors is a formidable challenge. With the help of environmental sensors, it can in principle be achieved before the noise becomes dominant by estimating correlations…
Sources of geophysical noise (such as wind, sea waves and earthquakes) or of anthropogenic noise impact ground-based gravitational-wave interferometric detectors, causing transient sensitivity worsening and gaps in data taking. During the…
At the time of this conference, in June 2002, The LIGO Science Collaboration was getting ready to perform its first Science Run, where data will be taken with all three LIGO detectors. We describe here the status of the LIGO detectors as of…
The LIGO experiment aims to detect and study gravitational waves using ground based laser interferometry. A critical factor to the performance of the interferometers, and a major consideration in the design of possible future upgrades, is…
Noise due to scattered light has been a frequent disturbance in the Advanced LIGO gravitational wave detectors, hindering the detection of gravitational waves. The non stationary scatter noise caused by low frequency motion can be…
The LIGO detectors collected about 4 months of data in 2003-2004 during two science runs, S2 and S3. Several environmental and auxiliary channels that monitor the instruments' physical environment and overall interferometric operation were…
Gravitational waves from binary black hole and neutron star mergers are being regularly detected. As of 2021, ninety confident gravitational wave detections have been made by the LIGO and Virgo detectors. Work is ongoing to further increase…
The LIGO Scientific Collaboration (LSC) glitch group is part of the LIGO detector characterization effort. It consists of data analysts and detector experts who, during and after science runs, collaborate for a better understanding of noise…
Progress in gravitational-wave astronomy depends upon having sensitive detectors with good data quality. Since the end of the LIGO-Virgo-KAGRA third Observing run in March 2020, detector-characterization efforts have lead to increased…
Data from the LIGO detectors typically contain many non-Gaussian noise transients which arise due to instrumental and environmental conditions. These non-Gaussian transients can be an issue for the modelled and unmodelled transient…
The Advanced LIGO detectors have recently completed their second observation run successfully. The run lasted for approximately 10 months and lead to multiple new discoveries. The sensitivity to gravitational waves was partially limited by…
On September 14, 2015, a gravitational wave signal from a coalescing black hole binary system was observed by the Advanced LIGO detectors. This paper describes the transient noise backgrounds used to determine the significance of the event…
Interferometric gravitational-wave detectors like LIGO, GEO600 and Virgo record a surplus of information above and beyond possible gravitational-wave events. These auxiliary channels capture information about the state of the detector and…
On April 1st, 2019, the Advanced Laser Interferometer Gravitational-Wave Observatory (aLIGO), joined by the Advanced Virgo detector, began the third observing run, a year-long dedicated search for gravitational radiation. The LIGO detectors…
Environmental noise is one of the critical issues for the observation of gravitational waves, but is difficult to predict in advance. Therefore, to evaluate the adverse impact of environmental noise on the detector sensitivity,…