相关论文: Optimization of Signal-to-Noise-and-Distortion Rat…

Signal to Noise Ratio (SNR) is an important index for wireless communications. There are many methods for increasing SNR. In CDMA systems, spreading sequences are used. We consider the frequency-selective wide-sense-stationary…

Signal to Noise Ratio (SNR) is an important index for wireless communications. In CDMA systems, spreading sequences are utilized. This series of papers show the method to derive spreading sequences as the solutions of non-linear…

Signal to Noise Ratio (SNR) is an important index for wireless communications. In CDMA systems, spreading sequences are utilized. This series of papers show the method to derive spreading sequences as the solutions of the non-linear…

Signal to Noise Ratio (SNR) is an important index for wireless communications. There are many methods for increasing SNR. In CDMA systems, spreading sequences are used. To increase SNR, we have to improve spreading sequences. In classical…

Recently, deep neural network (DNN) has made a breakthrough in monaural source enhancement. Through a training step by using a large amount of data, DNN estimates a mapping between mixed signals and clean signals. At this time, we use an…

In contrast to radio frequency (RF), where the modulation bandwidth is restricted by regulations to avoid interference, the available bandwidth in optical wireless communication (OWC) is primarily constrained by system components. To…

Real-world wireless transmitter front-ends exhibit certain nonlinear behavior, e.g., signal clipping by a Power Amplifier (PA). Although many resource allocation solutions do not consider this for simplicity, it leads to inaccurate results…

Throughput optimization of optical communication systems is a key challenge for current optical networks. The use of gain-flattening filters (GFFs) simplifies the problem at the cost of insertion loss, higher power consumption and…

Physical transceivers have hardware impairments that create distortions which degrade the performance of communication systems. The vast majority of technical contributions in the area of relaying neglect hardware impairments and, thus,…

High amplitude impulsive noise (IN) occurrence over power line channels severely degrades the performance of Orthogonal Frequency Division Multiplexing (OFDM)systems. One of the simplest methods to reduce IN is to precede the OFDM…

Flexible optical network is a promising technology to accommodate high-capacity demands in next-generation networks. To ensure uninterrupted communication, existing lightpath provisioning schemes are mainly done with the assumption of…

In future B5G/6G broadband communication systems, non-linear signal distortion caused by the impairment of transmit power amplifier (PA) can severely degrade the communication performance, especially when uplink users share the wireless…

M-MIMO is one of the crucial technologies for increasing spectral and energy efficiency of wireless networks. Most of the current works assume that M-MIMO arrays are equipped with a linear front end. However, ongoing efforts to make…

Dual functional radar and communication (DFRC) systems are a viable approach to extend the services of future communication systems. Most studies designing DFRC systems assume that the target direction is known. In our paper, we address a…

The efficiency of digital nonlinearity compensation (NLC) is analyzed in the presence of noise arising from amplified spontaneous emission noise (ASE) as well as from a non-ideal transceiver subsystem. Its impact on signal-to-noise ratio…

Signal clipping is a classic technique for reducing peak-to-average power ratio (PAPR) in orthogonal frequency division multiplexing (OFDM) systems. It has been widely applied in consumer electronic devices owing to its low complexity and…

DSP (digital signal processing) has been widely applied in optical communication systems to mitigate signal distortions and has become one of the key technologies that have sustained data traffic growth over the past decade. However, the…

The rate optimization for wireless networks with low SNR is investigated. While the capacity in the limit of disappearing SNR is known to be linear for fading and non-fading channels, we study the problem of operating in low SNR wireless…

This paper proposes novel spectrum sensing algorithms for cognitive radio networks. By assuming known transmitter pulse shaping filter, synchronous and asynchronous receiver scenarios have been considered. For each of these scenarios, the…

Novel methods and technology drive the rapid advances of nuclear magnetic resonance (NMR). The primary objective of developing novel hardware is to improve sensitivity and reliability (and possibly to reduce cost). Automation has made NMR…