相关论文: Extracting superconducting parameters from surface…
Superconducting single-flux-quantum (SFQ) circuits have so far been developed and optimized for operation at or above helium temperatures. The SFQ approach, however, should also provide potentially viable and scalable control and read-out…
When a superconducting radiofrequency cavity is cooled through its critical temperature, ambient magnetic flux can become "frozen in" to the superconductor, resulting in degradation of the quality factor. This is especially problematic in…
Thermodynamic quantities are derived for superconducting and pseudogap regimes by taking into account both amplitude and phase fluctuations of the pairing field. In the normal (pseudogap) state of the underdoped cuprates, two domains have…
As the number of qubits in nascent quantum processing units increases, the connectorized RF (radio frequency) analog circuits used in first generation experiments become exceedingly complex. The physical size, cost and electrical failure…
The complex surface impedance of a number of GdBa$_2$Cu$_3$O$_{7-\delta}$ single crystals has been measured at 10, 15 and 21 GHz using a cavity perturbation technique. At low temperatures a marked increase in the effective penetration depth…
Precision measurements of active and reactive components of in-plane microwave surface impedance were performed in single crystals of optimally-doped Fe-based superconductor Ba(Fe1-xCox)2As2 (x = 0.074, Tc = 22.8 K). Measurements in a…
Qubit readout is a critical part of any quantum computer including the superconducting-qubit-based one. The readout fidelity is affected by the readout pulse width, readout pulse energy, resonator design, qubit design, qubit-resonator…
A theory of strongly correlated electron or hole liquids with the fermion condensate is presented and applied to the consideration of quasiparticle excitations in high temperature superconductors, in their superconducting and normal states.…
We investigate the characteristics and noise performance of rf Superconducting Quantum Interference Devices (SQUIDs) by solving the corresponding Langevin equations numerically and optimizing the model parameters with respect to noise…
Utilizing tantalum (Ta) in superconducting circuits has led to significant improvements, such as high qubit lifetimes and quality factors in both qubits and resonators, underscoring the importance of material optimization in quantum device…
In this paper, I present an analysis of the electrical resistance graphs in Nature volume 586, pages 373-377 (2020), which reported the discovery of room temperature superconductivity in a carbonaceous sulfur hydride and was subsequently…
By determining the superconducting lower and upper critical fields $H_\mathrm{c1}(T)$ and $H_\mathrm{c2}(T)$, respectively, in a high-purity spherical Sr$_2$RuO$_4$ sample via ac-susceptibility measurements, we obtain the temperature…
Deterioration of the operation parameters of Al/SiO2/p-type Si surface barrier detector upon irradiation with alpha-particles at room temperature was investigated. As a result of 40-days irradiation with a total fluence of 8*10^9…
High transition temperature (high-Tc) superconductivity is associated with layered crystal structures. This work considers superconductivity in ultra-thin crystals (of thickness equal to the transverse structural periodicity distance d for…
We report on infrared reflectivity measurements of the $ab$-plane response of superconducting Bi$_2$Sr$_2$CuO$_6$ single crystals. The frequency dependent conductivity has a maximum near 700 cm$^{-1}$ at room temperature, which shifts to…
A resonance-induced change in the resistivity of the surface state electrons (SSE) exposed to the microwave (MW) radiation is observed. The MW frequency corresponds to the transition energy between two lowest Rydberg energy levels. All…
By measuring the electrical transport properties of superconducting NbN quarter-wave resonators in direct contact with a helium bath, we have demonstrated a high-speed and spatially sensitive sensor for the permittivity of helium. In our…
Electrical transport measurements were made on single-crystal Sn nanowires to understand the intrinsic dissipation mechanisms of a one-dimensional superconductor. While the resistance of wires of diameter larger than 70 nm drops…
In this research, it is shown that there are the necessary physical conditions to originate the returning superconductivity in the thin interface layer at the contact between the normal metal and the high temperature superconductor (N-S…
The minimal magnetic field $H_{c2}$ destroying superconductivity in the {\it bulk} of a superconductor is smaller than the magnetic field $H_{c3}$ needed to destroy {\it surface} superconductivity if the surface of the superconductor…