相关论文: Power requirements for electron cyclotron current …

Inclusive single jet production in hadron collisions is considered. It is shown that the QCD parton model predicts a nonmonotonic dependence of the inclusive cross section on the fraction of the energy deposited in the jet registered, if it…

Ionic current rectification (ICR) induced by electroosmotic flow (EOF) under concentration gradients can find many applications in micro/nanofluidic sensing and ionic circuits. Here, we focused on the cases with micropores of moderate…

The heat flux mitigation during the Thermal Quench (TQ) by the Shattered Pellet Injection (SPI) is one of the major elements of disruption mitigation strategy for ITER. It's efficiency greatly depends on the SPI and the target plasma, and…

In this paper, the calorimetric power measurement method for electron cyclotron resonance heating system on EAST are presented. This method requires measurement of the water flow through the cooling circuits and the input and output water…

A new compact electron cyclotron resonance (ECR) ion source for low current applications, designed and built in-house at the University of the Basque Country (UPV/EHU) is presented. The source was designed to use as many commercially…

We compute the electric dipole moment (EDM) of the deuteron in the holographic QCD model of Witten-Sakai-Sugimoto. Previously, the leading contribution to the EDM of nucleons was computed, finding opposite values for the proton and the…

This paper focuses on accelerated aging methods for magnet wire. Reliability of electrical devices such as coils, motors, relays, solenoids and transformers is heavily dependent on the Electrical Insulation System (EIS). Accelerated aging…

We present the technical and engineering design of a medium energy (10 MeV) and high average power (1 MW) electron beam accelerator intended for irradiation treatment of high volume industrial and municipal wastewater. The accelerator uses…

The upgrade of the normal conducting (NC) Radioactive Ion Beam EXperiment (REX)-ISOLDE heavy ion accelerator at CERN, under the High Intensity and Energy (HIE)-ISOLDE framework, proposes the use of superconducting (SC) quarter-wave…

The electroweak (EW) phase transition in the early Universe might be supercooled due to the presence of the classical scale invariance involving Beyond the Standard Model (BSM) sectors and the supercooling could persist down till a later…

Absolute cross sections for electron-impact single ionisation (EISI) of multiply charged tungsten ions (W$^{q+}$) with charge states in the range $ 11 \leq q \leq 18$ in the electron-ion collision energy ranges from below the respective…

Electron-magnon coupling at the interface between a normal metal and a magnetically ordered insulator modifies the electrical conductivity of the normal metal, an effect known as spin-Hall magnetoresistance. It can also facilitate…

Disruptions are a serious problem in tokamaks, in which thermal and magnetic energy confinement is lost. This paper uses data from the DIII-D experiment, theory, and simulations to demonstrate that resistive wall tearing modes (RWTM)…

Important features of Electron Cyclotron Resonance Ion Source (ECRIS) operation are accurately reproduced with a numerical code. The code uses the particle-in-cell technique to model a dynamics of ions in ECRIS plasma. It is shown that gas…

Quench protection of full-size high-field accelerator magnets poses significant challenges. Maintaining the hot-spot temperature and peak voltage-to-ground within acceptable limits requires a protection system that quickly transitions most…

Future high-power (10 - 20 MW) hadron accelerators offer many unique opportunities for fundamental science and nuclear applications. With the completion of Proton Power Upgrade (PPU) at 2.8 MW [1] and European Spallation Source (ESS) at 5…

We study theoretically the efficiency of an asymmetric superconducting quantum interference device (SQUID) which is constructed as a loop with three capacitively and resistively shunted Josephson junctions. Two junctions are placed in…

The electron Bernstein wave (EBW) is typically the only wave in the electron cyclotron (EC) range that can be applied in spherical tokamaks for heating and current drive (H&CD). Spherical tokamaks (STs) operate generally in high-beta…

The stabilization of tearing modes with rf waves is subject to a nonlinear effect, termed rf current condensation, that has the potential to greatly enhance and localize current driven within magnetic islands. Here we extend previous…

Singlet-polaron and triplet-polaron annihilation mechanisms are the most detrimental exciton quenching processes that lower the efficiency of organic light-emitting diodes (OLEDs) at high current densities, causing so-called efficiency…