相关论文: Low complexity sum rate maximization for single an…

Signal-to-leakage-and-noise ratio (SLNR) is a promising criterion for linear precoder design in multi-user (MU) multiple-input multiple-output (MIMO) systems. It decouples the precoder design problem and makes closed-form solution…

In this paper, multi-stream transmission in interference networks aided by multiple amplify-and-forward (AF) relays in the presence of direct links is considered. The objective is to minimize the sum power of transmitters and relays by…

In Part II of this two-part paper, a sum-rate-maximizing power allocation with minimum power consumption is found for multiple-input multiple-output (MIMO) decode-and-forward (DF) two-way relaying (TWR) in a network optimization scenario.…

We analyze scheduling algorithms for multiuser communication systems with users having multiple antennas and linear receivers. When there is no feedback of channel information, we consider a common round robin scheduling algorithm, and…

Signal-to-interference plus noise ratio (SINR) and rate fairness in a system are substantial quality-of-service (QoS) metrics. The acclaimed SINR maximization (max-SINR) algorithm does not achieve fairness between user's streams, i.e.,…

Interference alignment is a signaling technique that provides high multiplexing gain in the interference channel. It can be extended to multi-hop interference channels, where relays aid transmission between sources and destinations. In…

We consider joint beamforming and stream allocation to maximize the weighted sum rate (WSR) for non-coherent joint transmission (NCJT) in user-centric cell-free MIMO networks, where distributed access points (APs) are organized in clusters…

We propose an algorithm to maximize the instantaneous sum data rate transmitted by a base station in the downlink of a multiuser multiple-input, multiple-output system. The transmitter and the receivers may each be equipped with multiple…

This paper addresses joint transceiver and relay design for a wireless multiple-input-multiple-output (MIMO) switching scheme that enables data exchange among multiple users. Here, a multi-antenna relay linearly precodes the received…

Relays in cellular systems are interference limited. The highest end-to-end sum rates are achieved when the relays are jointly optimized with the transmit strategy. Unfortunately, interference couples the links together making joint…

In this paper, we consider linear MIMO transceiver design for a cellular two-way amplify-and-forward relaying system consisting of a single multi-antenna base station, a single multi-antenna relay station, and multiple multi-antenna mobile…

In this paper, we consider a multihop wireless sensor network (WSN) with multiple relay nodes for each hop where the amplify-and-forward (AF) scheme is employed. We present a strategy to jointly design the linear receiver and the power…

Two-way relaying networks (TWRNs) allow for more bandwidth efficient use of the available spectrum since they allow for simultaneous information exchange between two users with the assistance of an intermediate relay node. However, due to…

This work deals with turbo coded single user massive multiple input multiple output (SU-MMIMO) systems, with and without precoding. SU-MMIMO has a much higher spectral efficiency compared to multi-user massive MIMO (MU-MMIMO) since…

We consider a downlink multiuser multiple-input multiple output (MIMO) system employing regularized zero-forcing (RZF) precoding. We derive the asymptotic signal-to-leakage-plus-noise ratio (SLNR) as both the number of antennas and the…

In this paper, we design an association scheme to maximize the sum energy efficiency for massive multiple-input and multiple-output (MIMO) enabled heterogeneous cellular networks (HCNs). Considering that the final formulated problem is in a…

This letter is concerned with transmit and receive filter optimization for the K-user MIMO interference channel. Specifically, linear transmit and receive filter sets are designed which maximize the weighted sum rate while allowing each…

This paper proposes a joint transmitter-receiver design to minimize the weighted sum power under the post-processing signal-to-interference-and-noise ratio (post-SINR) constraints for all subchannels. Simulation results demonstrate that the…

Multichannel frequency estimation with incomplete data and miscellaneous noises arises in array signal processing, modal analysis, wireless communications, and so on. In this paper, we consider maximum-likelihood(-like) optimization methods…

This work revisits a recently proposed precoding design for massive multiple-input multiple output (MIMO) systems that is based on the use of an instantaneous total power constraint. The main advantages of this technique lie in its…