相关论文: A vector control and data acquisition system for t…

The Fermi Large Area Telescope (LAT) consists of 16 towers, each incorporating a tracker made up of a stack of 18 pairs of orthogonal silicon strip detectors (SSDs), interspersed with tungsten converter foils. The strip numbers of the…

The LIGO Interferometer Sensing and Control System (ISC) is a large and highly distributed Multiple Input Multiple Output (MIMO) control system that is used to control the length and alignment degrees of freedom of the interferometers. The…

A 20 GHz LLRF system is being built using a two-board(RF Front End + ADC/DAC/FPGA) architecture. The RF Front End provides 8 down-converting channels and 3 up-converting channels (5.5-20 GHz RF to 0.05-3 GHz IF). Separate, phase locked,…

The Data Acquisition System of the LZ experiment, the 10-tonne dark matter detector to be installed at the Sanford Underground Research Facility (SURF), will collect signals from 788 photomultiplier tubes (PMTs). Because the signals from…

Fermi National Accelerator Laboratory is constructing an Advanced Accelerator Research and Development facility at New Muon Lab. The cryogenic infrastructure in support of the initial phase of the facility consists of two Tevatron style…

The first version of digital low level RF (DLLRF) for the Diamond Light Source storage ring and booster was developed with ALBA Synchrotron. Six systems have been built so far. Two of them are in routine operation controlling two normal…

We describe micro-fabricated rubidium vapor cells with integrated temperature-control functionality and demonstrate their suitability for use in miniaturized ultra-sensitive magnetometers. These functionalized vapor cells (FVCs) embody a…

Long baseline laser interferometers used for gravitational wave detection have proven to be very complicated to control. In order to have sufficient sensitivity to astrophysical gravitational waves, a set of multiple coupled optical…

Radio Frequency (RF) power studies are in progress following the cryogenic commissioning of Cryomodule #1 (CM1) at Fermilab's Superconducting Radio Frequency (SRF) Accelerator Test Facility. These studies are complemented by the…

This paper presents a novel load frequency control (LFC) design using integral-based decentralize fixed-order perturbed dynamic output tracking scheme in a delay dependent nonlinear interconnected multi-area power system via LMI approach.…

Fast and Relaxed Vector Fitting (FRVF) is a frequency-domain system identification approach that has been widely adopted in electrical system modelling, while its application to mechanical systems has remained relatively unexplored. In this…

The design, fabrication and performance of an apparatus for the measurement of direct rf power absorption in colossal magnetoresistive (CMR) and superconducting samples are described. The system consists of a self-resonant LC tank circuit…

Deep phase modulation interferometry was proposed as a method to enhance homodyne interferometers to work over many fringes. In this scheme, a sinusoidal phase modulation is applied in one arm while the demodulation takes place as a…

Laser powder bed fusion (LPBF) is an additive manufacturing technique that has gained popularity thanks to its ability to produce geometrically complex, fully dense metal parts. However, these parts are prone to internal defects and…

We discuss a cryogenic, multi-object near-infrared spectrometer as a second generation instrument for the VLT. The spectrometer combines 20 to 40 independent integral eld units (IFUs), which can be positioned by a cryogenic robot over the…

The electric grid is undergoing a major transition from fossil fuel-based power generation to renewable energy sources, typically interfaced to the grid via power electronics. The future power systems are thus expected to face increased…

GRAVITY acquisition camera implements four optical functions to track multiple beams of Very Large Telescope Interferometer (VLTI): a) pupil tracker: a $2 \times 2$ lenslet images four pupil reference lasers mounted on the spiders of…

In a partnership with SLAC National Accelerator Laboratory (SLAC) and Jefferson Lab, Fermilab will assemble and test 17 of the 35 total 1.3 GHz cryomodules for the Linac Coherent Light Source II (LCLS-II) Project. These include a prototype…

We present in this paper an innovative data reduction method for single-mode interferometry. It has been specifically developed for the AMBER instrument, the three-beam combiner of the Very Large Telescope Interferometer, but can be derived…

The innermost part of the ATLAS experiment will be a pixel detector containing around 1750 individual detector modules. A detector control system (DCS) is required to handle thousands of I/O channels with varying characteristics. The main…