相关论文: High-speed measurement of firearm primer blast wav…
Heat and pressure are ultimately transmitted via quantized degrees of freedom, like gas particles and phonons. While a continuous Brownian description of these noise sources is adequate to model measurements with relatively long integration…
Self-sustained detonation waves in flake aluminum dust/air mixtures have been studied in a tube of diameter 199 mm and length 32.4 m. A pressure sensor array of 32 sensors mounted around certain circumferences of the tube was used to…
Perturbations in the velocity profile of a laser-ablation-driven shock wave seeded by speckle in the spatial beam intensity (i.e., laser imprint) have been measured. Direct measurements of these velocity perturbations were recorded using a…
The article by Fernandez et al argues that, because of advances made in laser-produced neutron pulses, it should now be possible to measure temperature in samples loaded to elevated pressures, by neutron resonance spectrometry with neutrons…
The dipole mode synchrotron frequency is a basic beam parameter; it and a few similarly basic quantities measured at small time intervals serve to characterize the longitudinal beam dynamics throughout the acceleration cycle. The effective…
Radio pulses from pulsars are affected by plasma dispersion, which results in a frequency-dependent propagation delay. Variations in the magnitude of this effect lead to an additional source of red noise in pulsar timing experiments,…
To achieve an uncertainty of 0.25 mK in single-pressure refractive-index gas thermometry (SPRIGT), the relative pressure variation of He-4 gas in the range 30 kPa to 90 kPa, should not exceed 4 ppm (k=1). To this end, a novel pressure…
Dipole wakefields in NLC (Next Linear Collider) structures have been measured with ASSET [1] and well predicted by a circuit model [2]. However, the experimental technique is both time-consuming and expensive. Here, we report on kick factor…
The results of the experiments on recording hard gamma radiation and measurements of its angular distribution at the initial stage of a laboratory high-voltage atmospheric discharge are presented. The experiments were performed on an ERG…
We have demonstrated the feasibility of performing high-frame-rate, fast neutron radiography of air-water two-phase flows in a thin channel with rectangular cross section. The experiments have been carried out at the accelerator facility of…
A method of measuring the thickness of steel plates using through transmission of an acoustic pulse is demonstrated. This study has been done on a stainless steel plate with regions of thickness 10:0 mm, 9:8 mm, and 9:6 mm, using broadband…
A method for estimating the base pressure in bluff body flows is proposed. The estimation uses the velocity at the separation edge with the Bernoulli equation to compute the base pressure. The assumption is that this is the base pressure…
Next-generation plasma-based accelerators can push electron beams to GeV energies within centimetre distances. The plasma, excited by a driver pulse, is indeed able to sustain huge electric fields that can efficiently accelerate a trailing…
A variety of experimental techniques for the generation of subsonic/supersonic dust fluid flows and means of measuring such flow velocities are presented. The experiments have been carried out in a $\Pi-$shaped Dusty Plasma Experimental…
A neutron source is proposed. It is based on a proton accelerator with the energy Ep = 1.2 GeV, current Ip = 0.7A, pulse duration T = 3 mcsec, repetition rate F = 60 Hz, and accelerator length L = 30 m. Protons are accelerated by the field…
In this paper we present the realization of further steps towards the measurement of the magnetic birefringence of the vacuum using pulsed fields. After describing our experiment, we report the calibration of our apparatus using nitrogen…
We study the evolution of the longitudinal release wave that is generated by induced tensile fracture as it propagates through solid rectangular Polymethylmethacrylate (PMMA) bars of different constant cross section. High speed multi-point…
In a typical experiment the nuclear \mu-capture rate is determined from measurements of the time constant of the muon decay exponential in a target. We propose a new approach for the evaluation of the \mu-capture rate, which is based on…
This paper presents a complex permittivity measurement method for low-dispersive materials as a function of frequency. The introduced method relies only on transmitted power signals which are collected using a spectrum analyzer/power meter,…
This paper describes the measurement of elliptic flow of charged particles in lead-lead collisions at sqrt(s_NN) = 2.76 TeV using the ATLAS detector at the Large Hadron Collider (LHC). The results are based on an integrated luminosity of…