相关论文: Hysteretic giant magnetoimpedance effect analyzed …

The magnetometric technique of First Order Reversal Curve (FORC) analysis, applicable to hysteretic systems, is introduced to the study of superconducting samples. Some typical superconducting structures in FORC diagram are identified, and…

This study is focused on the possibility to extend the use of the first-order reversal curve (FORC) diagram method to rate-dependent hysteresis. The FORCs for an amorphous magnetic wire was measured with an inductometric experimental setup…

The generic problem of extracting information on intrinsic particle properties from the whole class of interacting magnetic fine particle systems is a long standing and difficult inverse problem. As an example, the Switching Field…

A phenomenological model for the asymmetric giant magnetoimpedance (GMI) in field-annealed amorphous ribbons is developed. The effect of a surface crystalline layer on the GMI response is described in terms of an effective bias field…

Composite wires with a three-layered structure exhibit a large giant magneto-impedance (GMI) effect, which can be used in sensitive magnetic field sensors. To further investigate the origin of the GMI effect, composite wires consisting of a…

Giant magneto impedance (GMI) effect for as-cast Vitrovac$^{\textrm{\scriptsize\textregistered}}$ amorphous ribbons (Vacuumschmelze, Germany) in two configurations (parallel and normal to the ribbon axis) is studied over the frequency range…

A novel method to study the fundamental problem of quantum double well potential systems that display magnetic hysteresis is proposed. The method, coined quantum-first-order reversal curve (QFORC) analysis, is inspired by the conventional…

First Order Reversal Curve (FORC) diagrams are a popular tool in geophysics and materials science for the characterization of magnetic particles of natural and synthetic origin. However, there is still a lot of controversy about the…

A model describing the asymmetric giant magnetoimpedance (GMI) in field-annealed amorphous ribbons is proposed. It is assumed that the ribbon consists of an inner amorphous core and surface hard magnetic crystalline layers. The model is…

We apply the first-order reversal curve (FORC) method, borrowed from studies of ferromagnetic materials, to the magneto-structural phase transition of FeTe. FORC measurements reveal two features in the hysteretic phase transition, even in…

Magneto-impedance (MI) effects have been observed for amorphous Fe73.5Nb3Cu1Si13.5B9 ribbon which has been excited by an a.c. magnetic field parallel to the length of the ribbon. Maximum relative change in MI as large as -99% was observed…

We test the predictive power of first-oder reversal curve (FORC) diagrams using simulations of random magnets. In particular, we compute a histogram of the switching fields of the underlying microscopic switching units along the major…

Combined first order reversal curve (FORC) analyses of the magnetization (M-FORC) and magnetoresistance (MR-FORC) have been employed to provide a comprehensive study of the M-MR correlation in two canonical systems: a NiFe/Cu/FePt pseudo…

The first-order reversal curve (FORC) method for analysis of systems undergoing hysteresis is applied to dynamical models of electrochemical adsorption. In this setting, the method can not only differentiate between discontinuous and…

Multiphase magnetic systems are common in nature and are increasingly being recognized in technical applications. One characterization method which has shown great promise for determining separate and collective effects of multiphase…

This paper proposes a new model for Giant Magnetoresistance (GMR) and calculates its typical graph qualitatively. The model foundation is the microscopic mechanism in GMR, where the GMR effect can be explained by intrinsic and extrinsic…

We report a novel singularity in the hysteresis of spin glasses, the reversal-field memory effect, which creates a non-analyticity in the magnetization curves at a particular point related to the history of the sample. The origin of the…

First-order reversal curves (FORC) measurements are broadly used for characterization of complex magnetic nanostructures, but a robust framework for quantitative analysis of the FORC data is still obscure despite numerous studies over…

The first-order reversal curve (FORC) method is applied to the two-dimensional kinetic Ising model. For the system size and magnetic field chosen, the system reverses by the homogeneous nucleation and growth of many droplets. This makes the…

We use numerically unbiased methods to show that the one-dimensional Hubbard model with periodically distributed on-site interactions already contains the minimal ingredients to display the phenomenon of magnetoresistance; i.e., by applying…