相关论文: Measuring Black Hole Spin by the Continuum-Fitting…

The spins of ten stellar black holes have been measured using the continuum-fitting method. These black holes are located in two distinct classes of X-ray binary systems, one that is persistently X-ray bright and another that is transient.…

We use the Novikov-Thorne thin disk model to fit the thermal continuum X-ray spectra of black hole X-ray binaries, and thereby extract the dimensionless spin parameter a* = a/M of the black hole as a parameter of the fit. We summarize the…

We have used the Novikov-Thorne thin disk model to fit the continuum X-ray spectra of three transient black hole X-ray binaries in the thermal state. From the fits we estimate the dimensionless spin parameters of the black holes to be: 4U…

All prior work on measuring the spins of stellar-mass black holes via the X-ray continuum-fitting method has relied on the use of weakly-Comptonized spectra obtained in the thermal dominant state. Using a self-consistent Comptonization…

The analysis of the thermal spectrum of geometrically thin and optically thick accretion disks of black holes, the so-called continuum-fitting method, is one of the leading techniques for measuring black hole spins. Current models normally…

X-ray reflection spectroscopy has evolved as one of the leading methods to measure black hole spins. However, the question is whether its measurements are subjected to systematic biases, especially considering the possible discrepancy…

We describe a program that we have embarked on to estimate the spins of stellar-mass black holes in X-ray binaries. We fit the continuum X-ray spectrum of the radiation from the accretion disk using the standard thin disk model, and extract…

The two established techniques for measuring black hole spin in X-ray binaries often yield conflicting results, which must be resolved before either method may be deemed robust. In practice, black hole spin measurements based on fitting the…

We present a re-analysis of the XMM-Newton and NuSTAR observing campaign for the well-studied, X-ray-bright AGN MCG-06-30-15. In particular, we consider a disc model with finite thickness. By fitting the disc reflection spectra in the data,…

We present the results of a new series of global 3D relativistic magneto-hydrodynamic (MHD) simulations of thin accretion disks around spinning black holes. The disks have aspect ratios of $H/R\sim 0.05$ and spin parameters $a/M=0, 0.5,…

The black-hole spin parameter, $a_*$, was measured to be close to its maximum value of 1 in many accreting X-ray binaries. In particular, $a_*\gtrsim 0.9$ was found in a number of studies of LMC X-1. These measurements were claimed to take…

The continuum-fitting method is one of the two most advanced methods of determining the black hole spin in accreting X-ray binary systems. There are, however, still some unresolved issues with the underlying disk models. One of them…

We show that disc continuum fitting can be used to constrain black hole spin in a subclass of Narrow Line Seyfert 1 (NLS1) AGN as their low mass and high mass accretion rate means that the disc peaks at energies just below the soft X-ray…

A typical galaxy is thought to contain tens of millions of stellar-mass black holes, the collapsed remnants of once massive stars, and a single nuclear supermassive black hole. Both classes of black holes accrete gas from their…

Recent general relativistic magneto-hydrodynamic (MHD) simulations of accretion onto black holes have shown that, contrary to the basic assumptions of the Novikov-Thorne model, there can be substantial magnetic stress throughout the…

We present three simultaneous/quasi-simultaneous NuSTAR and Swift datasets of the black hole GRS 1716-249 in its hard intermediate state. The accretion disk in this state may have reached the innermost stable circular orbit, and the NuSTAR…

One of the primary means of determining the spin of an astrophysical black hole is by actually measuring the inner radius of a surrounding accretion disk and using that to infer the spin. By comparing a number of different estimates of the…

Building upon a new dynamical model for the X-ray binary LMC X-3, we measure the spin of its black hole primary via the continuum-fitting method. We consider over one thousand thermal-state RXTE X-ray spectra of LMC X-3. Using a large…

The spin of the black hole is an important parameter which may be responsible for the properties of the inflow and outflow of the material surrounding a black hole. Broad band IR/optical/UV spectrum of the quasar SDSS J094533.99+100950.1 is…

The development of techniques to measure accurately black hole spins is crucial to study the physics and astrophysics of these objects. X-ray reflection spectroscopy is currently the most popular method to estimate the spins of accreting…