相关论文: Fast sensing of double-dot charge arrangement and …

Measurement of charge configurations in few-electron quantum dots is a vital technique for spin-based quantum information processing. While fast and high-fidelity measurement is possible by using proximal quantum dot charge sensors, their…

Spin qubits in silicon quantum dots offer a promising platform for a quantum computer as they have a long coherence time and scalability. The charge sensing technique plays an essential role in reading out the spin qubit as well as tuning…

We report fast, simultaneous charge sensing and transport measurements of gate-defined carbon nanotube quantum dots. Aluminum radio frequency single electron transistors (rf-SETs) capacitively coupled to the nanotube dot provide…

We report high-bandwidth charge sensing measurements using a GaAs quantum point contact embedded in a radio frequency impedance matching circuit (rf-QPC). With the rf-QPC biased near pinch-off where it is most sensitive to charge, we…

Quantum dot arrays are a versatile platform for the implementation of spin qubits, as high-bandwidth sensor dots can be integrated with single-, double- and triple-dot qubits yielding fast and high-fidelity qubit readout. However, for…

State readout is a key requirement for a quantum computer. For semiconductor-based qubit devices it is usually accomplished using a separate mesoscopic electrometer. Here we demonstrate a simple detection scheme in which a radio-frequency…

Laterally coupled charge sensing of quantum dots is highly desirable, because it enables measurement even when conduction through the quantum dot itself is suppressed. In this work, we demonstrate such charge sensing in a double top gated…

Electron spins in silicon quantum dots provide a promising route towards realising the large number of coupled qubits required for a useful quantum processor. At present, the requisite single-shot spin qubit measurements are performed using…

A double quantum dot charge detector, with one dot Coulomb coupled to the electron to be detected and the other modulated by a time-dependent plunger voltage, is analyzed in a minimal model. The signal and noise of the detector are…

Zinc oxide (ZnO) has garnered much attention as a promising material for quantum devices due to its unique characteristics. To utilize the potential of ZnO for quantum devices, the development of fundamental technological elements such as…

We report the dispersive charge-state readout of a double quantum dot in the few-electron regime using the in situ gate electrodes as sensitive detectors. We benchmark this gate-sensing technique against the well established quantum point…

An important requirement for spin-based quantum information processing is reliable and fast readout of electron spin states, allowing for feedback and error correction. However, common readout techniques often require additional gate…

We report on charge sensing measurements of a GaAs semiconductor quantum dot device using a radio frequency quantum point contact (rf-QPC). The rf-QPC is fully characterized at 4 K and milli-Kelvin temperatures and found to have a bandwidth…

Semiconductor spin qubits are a promising platform for quantum computing but remain vulnerable to charge noise. Accurate, in situ measurement of charge noise could enable closed-loop control and improve qubit performance. Here, we propose a…

Ultra-sensitive detectors and readout devices based on the radio frequency single electron transistor (rf-SET) combine near quantum-limited sensitivity with fast operation. Here we describe a twin rf-SET detector that uses two…

We demonstrate a new method for projective single-shot measurement of two electron spin states (singlet versus triplet) in an array of gate-defined lateral quantum dots in GaAs. The measurement has very high fidelity and is robust with…

The detection of the quantum dot charge state using a quantum point contact charge detector has opened a new exciting route for the investigation of quantum dot devices in recent years. In particular, time-resolved charge detection allowed…

We demonstrate fast readout of a double quantum dot (DQD) that is coupled to a superconducting resonator. Utilizing parametric amplification in a nonlinear operational mode, we improve the signal-to-noise ratio (SNR) by a factor of 2000…

Charge sensing is a sensitive technique for probing quantum devices, of particular importance for spin qubit readout. To achieve good readout sensitivities, the proximity of the charge sensor to the device to be measured is a necessity.…

We report charge sensing measurements of a silicon metal-oxide-semiconductor quantum dot using a single-electron transistor as a charge sensor with dynamic feedback control. Using digitallycontrolled feedback, the sensor exhibits sensitive…