相关论文: High sensitivity cantilevers for measuring persist…
Negatively charged nitrogen-vacancy (NV) centers in diamond have been extensively studied as a promising high sensitivity solid-state magnetic field sensor at room temperature. However, their use for current sensing applications is limited…
Nanomechanical resonator-based sensing devices are used in medical diagnostics based on their high-frequency dynamic behavior. Cantilevers fall into the category of Nanomechanical resonators. It also resembles a resonator whose shape is…
We present a compact current sensor based on a superconducting microwave lumped-element resonator with a nanowire kinetic inductor, operating at 4.2 K. The sensor is suitable for multiplexed readout in GHz range of large-format arrays of…
In this study, we present a novel method for measuring the magnetic susceptibility of liquids using a Mach-Zehnder interferometer. The proposed technique employs a ring magnet to deform the liquid, while a laser beam passes through the…
Developing robust microwave-field sensors is both fundamentally and practically important with a wide range of applications from astronomy to communication engineering. The Nitrogen-Vacancy (NV) center in diamond is an attractive candidate…
It is suggested that nano-mechanical cantilevers can be employed as high-Q filters to circumvent laser noise limitations on the sensitivity of frequency modulation spectroscopy. In this approach a cantilever is actuated by the radiation…
Single-chip CMOS-based biosensors that feature microcantilevers as transducer elements are presented. The cantilevers are functionalized for the capturing of specific analytes, e.g., proteins or DNA. The binding of the analyte changes the…
We consider a far infrared (terahertz), room-temperature detector based on a microcantilever sensor of the radiation pressure. This system has a significantly higher sensitivity than existing uncooled detectors in the far infrared…
A procedure for avoiding the quenching associated to a previously reported method for inducing currents in superconducting rings [H. Gonzalez-Jorge et al., Appl. Phys. Lett. 81, 4207 (2002)] is proposed. High persistent currents are induced…
In this paper we describe the current status of the CALDER project, which is developing ultra-sensitive light detectors based on superconductors for cryogenic applications. When we apply an AC current to a superconductor, the Cooper pairs…
We present here a novel cantilever based apparatus to perform translational stress or strain controlled rheology in very soft solids, and obtain simultaneous confocal imaging of the 3 dimensional microstructure. The stress is measured using…
High-frequency atomic force microscopy has enabled extraordinary new science through large bandwidth, high speed measurements of atomic and molecular structures. However, traditional optical detection schemes restrict the dimensions, and…
A transient and high sensitivity sensor based on high-Q microcavity is proposed and studied theoretically. There are two ways to realize the transient sensor: monitor the spectrum by fast scanning of probe laser frequency or monitor the…
Quantum sensing with solid-state spins offers the promise of high spatial resolution, bandwidth, and dynamic range at sensitivities comparable to more mature quantum sensing technologies, such as atomic vapor cells and superconducting…
We propose a high-sensitivity magnetometry scheme based on a diamond Raman laser with visible pump absorption by an ensemble of coherently microwave driven negatively charged nitrogen-vacancy centres (NV) in the same diamond crystal. The NV…
Active microelectromechanical systems can couple the nanomechanical domain with the electronic domain by integrating electronic sensing and actuation mechanisms into the micromechanical device. This enables very fast and sensitive…
Using the properties of the transfer matrix of one-dimensional quantum mechanical systems, we derive a technique to exactly compute the persistent current across a hybrid normal-superconducting-mesoscopic ring pierced by a magnetic flux Phi…
Single-photon detectors based on the superconducting transition-edge sensor are used in a number of visible to near-infrared applications, particularly for photon-number-resolving measurements in quantum information science. To be practical…
We introduce a contactless technique for probing superconductivity, metal-insulator transitions, and magnetic ordering in micron-sized samples under extreme pressure. Utilizing a multistage Lenz lens system, directly sputtered onto diamond…
Nitrogen vacancy (NV) centers in diamond have developed into a powerful solid-state platform for compact quantum sensors. However, high sensitivity measurements usually come with additional constraints on the pumping intensity of the laser…