相关论文: Simultaneous Reduction of Dynamic and Static Power…

Historically, VLSI designers have focused on increasing the speed and reducing the area of digital systems. However, the evolution of portable systems and advanced Deep Sub-Micron fabrication technologies have brought power dissipation as…

As technology scales down, the static power is expected to become a significant fraction of the total power. The exponential dependence of static power with the operating temperature makes the thermal profile estimation of high-performance…

This paper shows that not every scan cell contributes equally to the power consumption during scan based test. The transitions at some scan cells cause more toggles at the internal signal lines of a circuit than the transitions at other…

Power dissipation in the sequential systems of modern CPU integrated chips (CPU-IC viz., Silicon Chip) is in discussion since the last decade. Researchers have been cultivating many low power design methods to choose the best potential…

With the growing number of severe system disturbances and blackouts around the world, controlled system separation is becoming an increasingly important system integrity protection scheme (SIPS) to save the electric power system from a…

Power dissipation in sequential circuits is due to increased toggling count of Circuit under Test, which depends upon test vectors applied. If successive test vectors sequences have more toggling nature then it is sure that toggling rate of…

The goal of this work is to minimize the energy dissipation of embedded controllers without jeopardizing the quality of control (QoC). Taking advantage of the dynamic voltage scaling (DVS) technology, this paper develops a performance-aware…

Power dissipation in integrated circuits is one of the major concerns to the research community, at the verge when more number of transistors are integrated on a single chip. The substantial source of power dissipation in sequential…

Time-based dynamic models of cascading failures have been recognized as one of the most comprehensive methods of representing detailed cascading information and are often used for benchmarking and validation. This paper provides an overview…

Dynamic comparators are an essential part of low-power analog to digital converters (ADCs) and are referred to as one of the most important building blocks in mixed mode circuits. The power consumption and accuracy of dynamic comparators…

Ever-growing electrical loads are having a huge impact on the operation and stability of the power system. Moreover, the integration of renewable generation poses various challenges to the future power system, especially, regarding…

In many power system optimization problems, we observe that only a small fraction of the line flow constraints ever become active at the optimal solution, despite variations in the load profile and generation costs. This observation has…

Transient stability analysis (TSA) plays an important role in power system analysis to investigate the stability of power system. Traditionally, transient stability analysis methods have been developed using time domain simulation by means…

As transistor sizes reach the mesoscopic scale, the limitations of traditional methods in ensuring thermodynamic consistency have made power dissipation optimization in transistor amplifiers a critical challenge. Based on stochastic…

This paper proposes a novel wide-area control strategy for modulating the active power injections to damp the critical frequency oscillations in power systems, this includes the inter-area oscillations and the transient frequency swing. The…

We present hardware/software techniques to intelligently regulate supply voltage and clock frequency of intermittently-computing devices. These devices rely on ambient energy harvesting to power their operation and small capacitors as…

As power systems become more and more interconnected, the inter-area oscillations has become a serious factor limiting large power transfer among different areas. Underdamped (Undamped) inter-area oscillations may cause system breakup and…

In this paper, the power response of power electronic loads in case of voltage drops are measured and their dynamics are analysed. Based on this, dynamic simulation models are derived which can be used for voltage stability investigations.…

Power electronic devices such as HVDC and FACTS can be used to improve the damping of poorly damped inter-area modes in large power systems. This involves the use of wide-area feedback signals, which are transmitted via communication…

Various side-channel attacks (SCAs) on ICs have been successfully demonstrated and also mitigated to some degree. In the context of 3D ICs, however, prior art has mainly focused on efficient implementations of classical SCA countermeasures.…