Related papers: Coulomb blockade thermometry using a two-dimension…
A theoretical proposal that Coulomb-coupled quantum dots can be used as quantum probes to determine the temperature of a sample (i.e., an electronic reservoir) is proposed. Through the regulation of the positive or negative voltage bias in…
Temperature dependence of the tunnel magnetoresistance (TMR) was calculated in range of the quantum-ballistic model in the magnetic tunnel junctions (MTJs) with embedded nanoparticles (NPs). The electron tunnel transport through NP was…
We study the tunneling transport through a nanojunction in the far-from-equilibrium regime at relatively low temperatures. We show that the current-voltage characteristics is significantly modified as compared to the usual quasi-equilibrium…
We investigated theoretically the Coulomb drag effect in coupled 2D electron gases in a wide interval of magnetic field and temperature $ 1/\tau \ll \omega_c \ll E_F/\hbar$, $T \ll E_F$, $\tau$ being intralayer scattering time, $\omega_c$…
Coulomb crystals of cold trapped ions are a leading platform for the realisation of quantum processors and quantum simulations and, in quantum metrology, for the construction of optical atomic clocks and for fundamental tests of the…
The Coulomb energy of a small metallic island coupled to an electrode by a tunnel junction is investigated. We employ Monte Carlo simulations to determine the effective charging energy for arbitrary tunneling strength. For small tunneling…
We study the transport through a quantum dot coupled to two leads by single-mode point contacts. The linear conductance is calculated analytically as a function of a gate voltage and temperature T in the case when transmission coefficients…
We study the Coulomb blockade of tunneling through a double quantum dot. The temperature dependence of the linear conductance is strongly affected by the inter-dot tunneling. As the tunneling grows, a crossover from temperature-independent…
Temperature rise of qubits due to heating is a critical issue in large-scale quantum computers based on quantum-dot (QD) arrays. This leads to shorter coherence times, induced readout errors, and increased charge noise. Here, we propose a…
Measurements of current-voltage (I-V) characteristics of a high quality Al/Al$_2$O$_3$/Al junction at temperatures ranging from 3.5 K to 300 K have been used to extract the barrier properties. Fitting results using Simmons' model led to a…
We have studied thermal gradients in thin Cu and AlMn wires, both experimentally and theoretically. In the experiments, the wires were Joule heated non-uniformly at sub-Kelvin temperatures, and the resulting temperature gradients were…
A system with equal number of positive and negative charges confined in a box with a small but finite thickness is modeled as a function of temperature using mesoscale numerical simulations, for various values of the charges. The Coulomb…
We report the measurement of the current noise of a tunnel junction driven out-of-equilibrium by a temperature and/or voltage difference, i.e. the charge noise of heat and/or electrical current. This is achieved by a careful control of…
We study the thermoelectric transport of a small metallic island weakly coupled to two electrodes by tunnel junctions. In the Coulomb blockade regime, in the case when the ground state of the system corresponds to an even number of…
We numerically calculated the full capacitance matrices for both one-dimensional (1D) and two-dimensional (2D) quantum-dot arrays. We found it is necessary to use the full capacitance matrix in modeling coupled quantum dot arrays due to…
We report on the low temperature tunnel magnetoresistance (MR) in quasi one-dimensional (1D) nanofibers made of conjugated polymers. The MR voltage bias dependence reveals an enhancement (at low biases) and the oscillatory behavior at…
We investigate thermal transport in a serial asymmetric double quantum dot (DQD) coupled to two electron reservoirs with different temperatures. The inter- and intra-Coulomb interactions are taken into account in a Coulomb blockade DQD…
Temperature imaging of nanoscale systems is a fundamental problem which has myriad potential technological applications. For example, nanoscopic cold spots can be used for spot cooling electronic components while hot spots could be used for…
We have measured the current-voltage characteristics of small-capacitance single Josephson junctions at low temperatures (T < 0.04 K), where the strength of the coupling between the single junction and the electromagnetic environment was…
We report the cooling of electrons in nanoelectronic Coulomb blockade thermometers below 4 mK. Above 7 mK the devices are in good thermal contact with the environment, well isolated from electrical noise, and not susceptible to…