Related papers: A Wide Dynamic Range Read-out System For Resistive…
This paper present high precision halfwave rectifier circuit in dual phase output mode by 0.5 micrometer CMOS technology, plus or minus 1.5 V low voltage, it has received input signal and sent output current signal, respond in high…
The search for a compatible application of memristor-CMOS logic gates has remained elusive, as the data density benefits are offset by slow switching speeds and resistive dissipation. Active microdisplays typically prioritize pixel density…
Ensuring the stability of power systems is gaining more attraction today than ever before, due to the rapid growth of uncertainties in load and renewable energy penetration. Lately, wide area measurement system-based centralized controlling…
The potential application of advanced digital communication schemes in a future upgrade of the CMS Tracker readout optical links is currently being investigated at CERN. We show experimentally that multi-Gbit/s data rates are possible over…
In-memory computing is a promising alternative to traditional computer designs, as it helps overcome performance limits caused by the separation of memory and processing units. However, many current approaches struggle with unreliable…
To mitigate the impact of noise and interference on multi-level-cell (MLC) flash memory with the use of low-density parity-check (LDPC) codes, we propose a dynamic write-voltage design scheme considering the asymmetric property of raw bit…
The key feature of a memristor is that the resistance is a function of its previous resistance, thereby the behaviour of the device is influenced by changing the way in which potential is applied across it. Ultimately, information can be…
Memristors are promising next-generation memory candidates that are nonvolatile, possess low power requirements and are capable of nanoscale fabrication. In this article we physically realise and describe the use of organic memristors in…
This article is present high precision multiwave rectifier circuit operating in low voltage plus or minus 1.5 Volt current modes by CMOS technology 0.5 \mum, receive input and give output in current mode, respond at high frequency period.…
Single-photon detectors based on the superconducting transition-edge sensor are used in a number of visible to near-infrared applications, particularly for photon-number-resolving measurements in quantum information science. To be practical…
We present the development of a second generation digital readout system for photon counting microwave kinetic inductance detector (MKID) arrays operating in the optical and near-IR wavelength bands. Our system retains much of the core…
Networks with memristive devices are a potential basis for the next generation of computing devices. They are also an important model system for basic science, from modeling nanoscale conductivity to providing insight into the…
In the readout electronics of the Water Cerenkov Detector Array (WCDA) in the Large High Altitude Air Shower Observatory (LHAASO), both high-resolution charge and time measurement are required over a dynamic range from 1 photoelectron…
Reversible bipolar nano-switches that can be set and read electronically in a solid-state two-terminal device are very promising for applications. We have performed molecular-dynamics simulations that mimic systems with oxygen vacancies…
Memristive devices have been considered promising candidates for nature-inspired computing and in-memory information processing. However, experimental devices developed to date typically show significant variability and function at…
Scaling of multi-pixel cryogenic detectors for imaging becomes increasingly difficult with size due to complexity of readout circuitry and cryogenic constraints (thermal load from wiring). We propose and demonstrate a new readout scheme…
Memristive devices have drawn considerable research attention due to their potential applications in non-volatile memory and neuromorphic computing. The combination of resistive switching devices with light-responsive materials is…
Resistive switching devices and other components with negative differential resistance (NDR) are emerging as possible electronic constituents of next-generation computing architectures. Due to the NDR effects exhibited, switching operations…
Development of readout electronics for Time Projection Chamber for a Linear Collider is ongoing under stringent requirements on high channel density, lowest possible power consumption and small material budget. In the studied TPC readout…
An observer based adaptive detection methodology (ADM) is proposed for estimating frequency and its rate of change (RoCoF) of the voltage and/or current measurements acquired from an instrument transformer. With guaranteed convergence and…