Related papers: Short wavelength infrared avalanche photodetector …
Ultra-sensitive short-wave infrared (SWIR) photon detection is a crucial aspect of ongoing research in quantum technology. However, developing such detectors on a CMOS-compatible silicon technological platform has been challenging due to…
Engineering light absorption in the extended short-wave infrared (e-SWIR) range using scalable materials is a long-sought-after capability that is crucial to implement cost-effective and high-performance sensing and imaging technologies.…
The cross-plane thermal conductivity of a type II InAs/GaSb superlattice (T2SL) is measured from 13 K to 300 K using the 3{\omega} method. Thermal conductivity is reduced by up to 2 orders of magnitude relative to the GaSb bulk substrate.…
Infrared avalanche photodiode arrays represent a panacea for many branches of astronomy by enabling extremely low-noise, high-speed and even photon-counting measurements at near-infrared wavelengths. We recently demonstrated the use of an…
Controlling light penetration depth in Avalanche Photodiodes (APDs) and Single Photon Avalanche Diodes (SPADs) play a major role in achieving high multiplication gain by delivering light near the multiplication region where the electric…
Low Gain Avalanche Detectors (LGAD) are based on a n++-p+-p-p++ structure where an appropriate doping of the multiplication layer (p+) leads to high enough electric fields for impact ionization. Gain factors of few tens in charge…
Recent increasing interest in strain balanced Type-II superlattices material causing close attention from industry. Tremendous investment was drawn toward establishing strain balanced superlattice (SLS) as new alternative for infrared…
Avalanche photodiodes fabricated from AlInAsSb grown as a digital alloy exhibit low excess noise. In this paper, we investigate the band structure-related mechanisms that influence impact ionization. Band-structures calculated using an…
We used laser ablation to fabricate sub-wavelength structure anti-reflection coating (SWS-ARC) on a 5 cm diameter alumina lens. With an aspect ratio of 2.5, the SWS-ARC are designed to give a broad-band low reflectance response between 110…
An essential design requirement of the ALPS-II experiment is the efficient detection of single photons with a very low instrumental background of 10 {\mu}Hz. In 2011 the ALPS collaboration started to set up a TES detector (Transition-Edge…
The Low Gain Avalanche Diodes (LGADs) are promising particle detectors for timing resolution better than $50$ ps under a high radiation environment. This study investigates n-in-p LGAD architecture, focusing on ultra-thin sensors of…
A Large Area Avalanche Photodiode (LAAPD) was studied, aiming to access its performance as light detector at low temperatures, down to -80 C. The excess noise factor, F, was measured and found to be approximately independent of the…
Enhancing photon detection efficiency and time resolution in photodetectors in the entire visible range is critical to improve the image quality of time-of-flight (TOF)-based imaging systems and fluorescence lifetime imaging (FLIM). In this…
Type-II W-lasers have made an important contribution to the development of mid-infrared laser diodes. In this paper, we show that a similar approach can yield high performance lasers in the optical communications wavelength range.…
Single-photon detectors (SPDs) are the most sensitive instruments for light detection. In the near-infrared range, SPDs based on III-V compound semiconductor avalanche photodiodes have been extensively used during the past two decades for…
Single-photon detectors (SPDs) are widely used in applications requiring extremely weak light detection. In the near-infrared region, SPDs based on InGaAs/InP single-photon avalanche diodes (SPADs) are the primary candidates for practical…
Broadband mid-infrared (mid-IR) spectroscopy applications could greatly benefit from today's well-developed, highly scalable silicon photonics technology; however, this platform lacks broadband transparency due to its reliance on absorptive…
The wide-bandgap semiconductor 4H-silicon carbide (4H-SiC) offers a compelling combination of radiation hardness, thermal stability, and high critical electric field for particle detection in harsh environments. To compensate for the…
Characteristic properties of a Geiger Mode APD (G-APD) in a THGEM-based cryogenic two-phase Ar avalanche detector were studied in view of potential applications in rare-event experiments. G-APD signal amplitude and noise characteristics at…
Low-Gain Avalanche Detectors are gathering interest in the High-Energy Physics community thanks to their fast-timing and radiation-hardness properties, which are planned to be exploited, for example, in timing detectors for the upgrades of…