Related papers: Mirror Furnace for Synchrotron Dark Field X-ray Mi…
MADMAX, an axion dark matter search experiment, is currently in the prototype testing phase. Its working principle is based on the conversion of axions in a magnetic field into photons. This signal is then enhanced by a booster made of…
X-ray mirrors with high focusing performances are in use in both mirror modules for X-ray telescopes and in synchrotron and FEL (Free Electron Laser) beamlines. A degradation of the focus sharpness arises in general from geometrical…
Because of surface structural constraint and thermal management requirement, visible - infrared compatible camouflage is still a great challenge. In this study, we introduce a 2D periodic aperture array into ZnO/Ag/ZnO film to realize…
MOEMS Deformable Mirrors (DM) are key components for next generation instruments with innovative adaptive optics systems, in existing telescopes and in the future ELTs. These DMs must perform at room temperature as well as in cryogenic and…
Micro-focused X-ray beams produced by third generation synchrotron sources offer new perspective of studying strains and processes at nanoscale. Atomic force microscope setup combined with a micro-focused synchrotron beam allows precise…
X-ray magnetic circular dichroism (XMCD) has become an important and powerful tool because it allows the study of material properties in combination with elemental specificity, chemical state specificity, and magnetic specificity. A new…
We introduce the use of a crossed pair of Multilayer Laue Lenses (MLLs) as an objective in Dark-Field X-ray Microscopy (DFXM). In a demonstration experiment at the ID03 beamline at ESRF, two flat Mo-Si MLLs were used, with a physical…
X-ray calorimetric sample platforms combining specific heat and synchrotron x-ray measurements provide a powerful means to investigate fundamental material properties. Calorimeter cell designs featuring a compact heater and thermometer…
Experiments were performed with Fabry-Perot optical resonators in vacuum at low temperatures. Mirrors were applied on substrates of various optical materials. The infrared laser with a wavelength of 1.064 microns was used. The pump power at…
Mirror dark matter, a hidden-sector counterpart to the Standard Model with identical particle content, could be detectable through photon-mirror-photon kinetic mixing $(\epsilon)$. We present new constraints from CDEX-10 low-energy recoil…
This work builds on the previous introduction [1] of a coupled experimental-computational system devised to fully characterize the thermal behavior of complex 3D submicron electronic devices. The new system replaces the laser-based surface…
Enabling temperature dependent experiments in Atomic Force Microscopy is of great interest to study materials and surface properties at the nanoscale. By studying Curie temperature of multiferroic materials, temperature based phase…
The ability to probe nanoscale heat flow in a material is often limited by lack of spatial resolution. Here, we use a diamond-nanocrystal-hosted nitrogen-vacancy centre attached to the apex of a silicon thermal tip as a local temperature…
Active optics has attracted considerable interest from researchers in synchrotron radiation facilities, because of its capacity for x-ray wavefront correction. Here, we report a novel and efficient technique for correcting or modulating a…
The LAMP (Lightweight Asymmetry and Magnetism Probe) X-ray telescope is a mission concept to measure the polarization of X-ray astronomical sources at 250 eV via imaging mirrors that reflect at incidence angles near the polarization angle,…
We have grown intermetallic ErPd$_2$Si$_2$ single crystals employing laser-diodes with the floating-zone method. The temperature-dependent crystallography was determined using synchrotron and in-house X-ray powder diffraction measurements…
The Centrifugal Mirror Fusion Experiment (CMFX) at the University of Maryland, College Park is a rotating mirror device that utilizes a central cathode to generate a radial electric field which induces a strongly sheared azimuthal $E\times…
We have developed a low temperature, high resolution magnetic force microscope (MFM) using a quartz tuning fork that can operate in a magnetic field. A tuning fork with a spring constant of 1300 N/m mounted with a commercial MFM cantilever…
A floating zone furnace is a powerful tool for single crystal growth. Here, we report the floating zone furnace using a high power diode laser of 1kW composed of five 200 Watt heating beams. The five beams with the designed irradiation…
Dark-field X-ray microscopy is a new full-field imaging technique that nondestructively maps the structure and local strain inside deeply embedded crystalline elements in three dimensions. Placing an objective lens in the diffracted beam…